R&B Wire Products PSS-3C User manual

[e-mail] [phone] RBWIRE.COM
ASSEMBLY INSTRUCTIONS
R
STEP
1
STEP
2
STEP
3
(1) 9/16" wrench
TOOLS REQUIRED:
(2) 7/16"wrenches
1 person assembly
If you ordered a Mobile Privacy Screen, determine where
you want the 2 locking casters positioned. With the 9/16"
wrench, screw casters into legs
If you ordered a Stationary Privacy Screen, place each
of the four crutch tips onto the ends of the leg feet.
Carefully lay the frame of the Privacy Screen down
onto the ground. Insert the leg tubes into the frame
and secure them with two 7/16” wrenches and
hardware provided.
NOTE: Save the extra panel rod end clip for future use.
Once legs are installed, stand the unit upright and
open the frame up so curtain panels can be installed.
WARNING
!
MODEL PSS-3C
Mobile Privacy Screen
MODEL PSS-3
Stationary Privacy Screen
OR
HARDWARE INCLUDED (Not to scale)
x4 Nuts
x6 Curtain rods
· Never stand or ride on this product.
· Keep casters free of debris.
· Do not hang anything on this product.
· Use caution when rolling over uneven surface. x13 End clips
x4 Bolts
x4 Casters
x4 Crutch tips

[e-mail] [phone] RBWIRE.COM
ASSEMBLY INSTRUCTIONS
R
STEP
4
STEP
5
Complete the remaining two panel curtains the
same way. Adjust each one to provide even coverage.
Take one curtain out of the 3-pack, along with one
aluminum rod and 2 end clips. Slide the aluminum
rod into the top pocket. Insert the thick end of each
clip into each end of the rod. Bend the clip in half and
insert its thin end into the end currently in the rod.
Fit the tab into the hole on the frame and secure
both ends of the rod. Repeat for the bottom rod.
STEP
6
pg 2
MODEL PSS-3C or PSS-3
Standard 3-Panel Privacy Screen
Your 3-Panel Privacy Screen is ready for use.