RANGE MART RANGE TARGET User manual

WWW.RANGEMART.COM • 4142 ADAMS AVE SUITE 103217 • SAN DIEGO, CALIFORNIA 92116
[email protected] • 877.741.2678
RANGE TARGET ASSEMBLY INSTRUCTIONS

WWW.RANGEMART.COM • 4142 ADAMS AVE SUITE 103217 • SAN DIEGO, CALIFORNIA 92116
[email protected] • 877.741.2678
PARTS
The Range Target consists of the following assembly parts:
1) Base (1)
2) Top Hoop with Net (1)
3) Back Legs (2)
4) Front Leg (1)
5) Tee-Insert (6)
WEIGHT
Target can be secured to ground with stakes, but you must drill holes through base. Or
use dry playground sand (not included) if added weight is required. Use a funnel to pour
into legs. If using sand, be sure to add sand before assembling the Top Hoop.
ASSEMBLY INSTRUCTIONS
1) The Base is the smaller circle that does not have a net attached. Lay on the
ground or solid work surface.
2) Insert Back Legs first. The two Back Legs are longer than Front Leg. Insert Back
Legs into Tee-Inserts located inside the Base. When inserting the Back Legs, the
curvature of the legs should be curved away from the front as shown below. With
a rubber mallet, gently tap the top of the leg to secure into Tee-Insert.

WWW.RANGEMART.COM • 4142 ADAMS AVE SUITE 103217 • SAN DIEGO, CALIFORNIA 92116
[email protected] • 877.741.2678
3) After Back Legs are secure, insert Front Leg into Tee-Insert on base. The
curvature of the leg should be placed as show above. Gently tap into place with
rubber mallet.
4) Place the Top Hoop on top of Back Legs lining up the Hoop Tee-Inserts into the
top of the Legs. Gently tap with a rubber mallet to secure the Top Hoop into the
leg.

WWW.RANGEMART.COM • 4142 ADAMS AVE SUITE 103217 • SAN DIEGO, CALIFORNIA 92116
[email protected] • 877.741.2678
5) After Back Legs are secure, line up Front Leg with Top Hoop and secure Front
Leg with rubber mallet.

WWW.RANGEMART.COM • 4142 ADAMS AVE SUITE 103217 • SAN DIEGO, CALIFORNIA 92116
[email protected] • 877.741.2678