Harrod ANC-016 User manual

ASSEMBLY INSTRUCTIONS
i
i
2 people are recommended for this assembly
Estimated 60 minutes assembly time (not including time for concrete)
INS717
Revision 1
08/03/2017
ANC-016
Panoramic Team Shelter Anchors
60
mins
IMPORTANT: Please read these assembly instructions carefully before
anchoring your team shelter
IMPORTANT: mustThe sockets be installed in a minimum of 0.6m of
concrete. Consult a construction engineer for advice where required
3
*Panoramic Team Shelter sold separately

Pack Contents
17mm
Code
Product
ANC-016
Panoramic Team Shelter Anchor
Page 1
*parts are not to scale
Tools Required
2x 17mm Spanners
1x Spirit Level
1.
x2
FEP717
2.
x2
PEP331 (FEQ331)
3.
x2
FBL-291
Panoramic Team Shelter Anchor
1. Anchor Arm
2. Support Post
3. Socket
4. Anchor Fittings
(packed with Anchor Arm)
5.
x4
SEP497
6.
x4
BOL286
7.
x8
BOL709
8.
x12
BOL202
5. U Bar
6. M10x75mm Bolt
7. M10 Washer
8. M10 Nyloc Nut
Fittings Pack Contents

Page 2
Socket Installation
Code
Product
ANC-016
Panoramic Team Shelter Anchor
600mm
600mm 40mm
Refer to Table
Ground Level
Fence Line
360mm
from front
of fence
Playing Area
600mm
Dig holes at a 600mm and concrete Sockets flush with ground level. Leave 40mm
between concrete and ground level for turf replacement
minimum 3
IMPORTANT: Please ensure you mark out the correct socket centres
for your shelter, as shown in the table below:
i
Part No Length Centres
SHE-102 2m 2082mm
SHE-104 4m 4090mm
SHE-106 6m 6097mm
Socket Centres
PLAN VIEW
SIDE VIEW
3
IMPORTANT: Consult a construction engineer for advice where
required. Ensure Sockets are vertical and concrete fully hardened
before proceeding with your assembly
i
3
Drainage Hole

Page 3
Assembly Instructions
Code
Product
ANC-016
Panoramic Team Shelter Anchor
2Place M10x75mm Bolts and M10 Washers face up through the holes in the Shelter feet
Installing through fence only: Cut holes in fence for the anchor arms to pass through
7
6
90mm
90mm
Socket Centres
145mm
67

Page 4
5
2
1
7
8
17mm
Code
Product
ANC-016
Panoramic Team Shelter Anchor
3Insert Support Posts and attach Anchor Arms with U Bar and Nyloc Nuts . Align Anchor
Arms with exposed Bolts in Shelter and secure with M10 Washers and Nyloc Nuts
2158
7