RapidSignage RS-10 User manual

RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
RS-10 Quick Installation Guide
1
USB 2.0 (x2)
4
HDMI Output
2
LAN Port
5
DC in
3
Audio Out
6
microSD card slot
Package content:
-Power Adapter
6
5
4
1
3
2

RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
RS-10 Configuration
Direct Connect:
1. Connect the provided power adapter into the DC in (5)
2. Connect Ethernet cable to the computer and to LAN port (2).
3. Connect an HDMI cable to HDMI port (4)to an Videowall.
4. Configure your computer system’s network settings to:
a. IP address (TCP/IPv4): 192.168.100.2
b. Subnet mask: 255.255.255.0
5. Open your browser (Google Chrome is recommended) and connect to the RS-10:
c. Default URL: http://192.168.100.1
d. Default login: admin
e. Default password: admin

RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com
With DHCP networking:
If you want the RS-10 connect to a DHCP network, you need to directly connect with RS-10 first and
change the networking setting of the RS-10:
1. Click SystemConfig on the main page of RS-10, then click Network config Tab.
2. Double-click textbox of DHCP and make sure DHCP is turned on, then Click Apply.
3. Click Power tab, and click Reboot button to reboot the RS-10.
4. After reboot, the RS-10 IP address will be displayed on the boot screen.
Example:
Change the RS-10 into the diagram below:
AP / Router / Switch