Rasland MCB-DK001 User manual


Do not throw any hard objects on to the ceramic.
 

Do not scrub by using hard or rough objects on the ceramic or cabinet.

WARNING
1
1.2
1.1
3 

INSTALLATION PREPARATION


Be careful when moving the heavy objects. Please do ask for assistant.
 

The wall must be flat and built in vertically balance. The wall must be
strong and thick enough to hold the cabinet and ceramic basin.
 55-60 .
The standard height of the drain hole should be around 50-60 cms.
from the ground.
  85-90 . 

The standard height of the basin should be around 85-90 cms.
from the ground.
3.2
3.3
3.4
3.1

MAINTENANCE2
Do not leave stain on the cabinet or ceramic basin for long time.

ผลิตภัณฑ์
Please use normal water to clean the basin and the cabinet and
wipe to dry after each use.


To maintain the cabinet in a good condition, do not put the cabinet
soak with water. Do put in a dry place.
2.2
2.1
2.3
X W
W
mm X mm
16 834

 
    
 
Prior to installation
It Is important that the product is unpacked
and inspected for any damage, defects and
that the product supplied is correct. if any
of the above is apparent, do not proceed
with this installation, and immediately
contact the store of purchase.

CUSTOMER
SERVICE
@Rasland

 


080-075-8668
BATHROOM CARBINET
INSTALLATION GUIDE
Illustrations may
not reflect every
exact model
To install your bathroom products
please ensure you read the following
instructions below.
TOOLS REQUIRED (NOT PROVIDED) PROVIDED FITTING IN BATHROOM CABINET SET
 
This product is heavy and may require two people to install.
!
MCB DK001


INSTALLATION STEPS

Measure and drill holes


Screw and install the cabinet

Drill holes on the wall
  
Put the plastic socket into
the drilled holes
1
 
Scale for the balance of the cabinet

Make a mark

Plastic socket
2
4
3
 
 
Put the cabinet on the wall and
screw loosely on both sides.
1
 
 


Screw loosely on both sides with
the cabinet hanging.
2


Place the ceramic basin on the cabinet
and adjust the basin in the right position
 
Hinge adjustments of the door can be done further according to the illustration.
 


Seal the basin edge between wall and the basin
with silicone to protect water leak into the gap.
STEP
1STEP 3
STEP
2STEP 4
STEP
5

The screws