51 mm (2")
CUTOUT
10 mm (.4")
9 mm (.4")
8.5 mm (.33")
18.5 mm
(.73")
135 mm (5.3") CUTOUT
172 mm (6.8") ALLOWANCE FOR FLUSH MOUNT KIT
70 mm
(2.75")
190 mm (7.5") ALLOWANCE FOR FLUSH MOUNT KIT
150 mm (5.9") CUTOUT
61 mm
(2.4")
CUTOUT
8 mm (.3")
8 mm (.3")
10 mm (.4")
79 mm (3.1")
167 mm (6.6")
20 mm
(.8")
RAY48 VHF RADIO
ALLOW 110 mm (4.3") FROM RADIO MOUNTING SURFACE FOR RADIO DEPTH.
Ray48 Mounting Template
E46034 Flush Mounting Kit
for Ray48 & Ray54/E
3033-010
RAY48
RAY54
Pre-punched gaskets sheet
Gasket, 1 ea, Ray48 & Ray54/E
Bracket Subassembly, qty 2
5583-002 Flush Mount Assembly
Screw, M6, qty 2, and
Lock Washer, M6, qty 2
1. Use template to cut out required opening in console.
2. Remove appropriate Gasket from pre-punched sheet
and place on radio, behind front fascia.
3. Insert unit into cutout in console.
4. Attach both Bracket Subassemblies to radio using M6
Screws and Lock Washers.
5. Tighten Bracket Subassembly mounting screws until
unit snugly attached to console.
CUT OUT SHADED AREA
Ray54/E Mounting Template
CUT OUT SHADED AREA
