RDA LIGHTING 2HS User manual

2HS
INSTALLATION INSTRUCTIONS
2HS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE. SAVE THESE INSTRUCTIONS.
WARNING: Disconnect power during installation and before maintaining.
SAFETY: This fixture must be wired in accordance with the Canadian Electrical Code, and
applicable local codes and ordinances.
Proper grounding is required to ensure personal safety.
A qualified electrician should perform all wiring.
PRODUCT SPECIFICATION
Power Source: 120VAC/60Hz, 32.50W
With AC COB LED Chip: 2 pcs * 14W
Load Rating: No extra Lights should be added to this unit
INSTALLATION & WIRING:
Attach the crossbar to junction box using the mounting screws.
Connect black wire (live wire) from the AC power to the single black wire from the fixture.
Connect the white wire (common) from the AC power to the white wire from the fixture.
Connect the ground wire from the power side to the green/yellow wire (ground) from the fixture.
Make sure the polarity is correct.
Attach the light to the crossbar screws and secure with the screw nuts.
After installation, be sure to apply a bead of silicone compound all around backing where it meets
with the surface to ensure a weatherproof installation.
DO NOT MOUNT ON THE GROUND
Back plate screw
Mounting screw
Screw nut Wire nut
Silicone spacers
Cross bar
Fig. A
Recommended height installation: 6.5’TO 8.25’

2HS
AIM LAMP HEADS
Adjust the lamp head to get desired light direction
Turn on electricity at fuse or circuit breaker box and verify success of installation
Apply silicone caulking (not included) around the perimeter of the fixture where it contacts the
mounting surface for moisture seal