RDL RU-SMA1 User manual

ACCESSORIES
Model RU-SMA1
Surface Mounting Adapter
The RU-SMA1 is a plate for mounting a RACK-UP® module to any flat surface. The opening permits the mounting of either a RACK-UP
module or RDL AMS accessories. The RU-SMA1 is ideal for mounting a module into a cabinet or lectern.
Front Rear
With Product Installed
(RU-MX5ML available separately)
RDL •659 6th St. •Prescott, AZ., USA 86301 •[phone] •FAX [phone] •www.rdlnet.com

ACCESSORIES
Model RU-SMA1
Surface Mounting Adapter
891-5208A
Recommend Cutout:
STEP #1
Start the screws into the bottom of the RACK-UP but do
not install them all the way. Place the RACK-UP unit onto
the chassis. The screw heads will pass through the rear
position in the cutouts.
STEP #2
Slide the unit forward until the screws are seated in the
forward position of the cutout. Tighten the screws to
secure the unit in the chassis.
STEP #3
Secure the chassis to the mounting surface with the
screws.
Radio Design Labs Technical Support Centers
U.S.A. [phone], [phone]; Fax: [phone]
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
Installation/Operation
Declaration of Conformity available from rdlnet.com.
Sole EMC specications provided on product package.
Specications are subject to change without notice.