RDL WDG1R User manual

ACCESSORIES
Model WDG1R
Table Top Wedge Mount
The WDG1R is a tabletop enclosure for mounting any RACK-UP module. All steel construction.
Front Rear
With Product Installed
(RU-SH1 available separately)
RDL •659 6th St. •Prescott, AZ., USA 86301 •[phone] •FAX [phone] •www.rdlnet.com

ACCESSORIES
Model WDG1R
Table Top Wedge Mount
891-5545
STEP #2
Slide the unit forward until the screws are seated in the
forward position of the cutout. Tighten the screws to
secure the unit in the chassis.
STEP #3
Secure the chassis to the mounting surface with screws.
(Screws not included)
STEP #4
Slide the top cover toward the chassis. Once seated secure
the top cover to the chassis with the four included screws.
STEP #1
Start the screws into the bottom of the RACK-UP but do not install
them all the way. Place the RACK-UP onto the chassis. The screw
heads will pass through the rear position in the cutout.
Radio Design Labs Technical Support Centers
U.S.A. [phone], [phone]; Fax: [phone]
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4
Typical Performance reects product at publication time
exclusive of EMC data, if any, supplied with product.
Specications are subject to change without notice.
NOTE: When installing a RACK UP product that is in a
plastic box start by removing the screws from the back
of the RACK UP. Bend the tabs on the mounting unit up
at a 90° angle. Secure the unit to the mounting chassis
using the screws. Continue to Step 3.
NOTE: If the unit will not be permanently mounted to a
surface skip Step 3. Instead install the included feet using
the 6-32 screws. Install the feet in the locations shown on
the above drawing. Continue to Step 4.
(Bottom View)