Realfiction Dreamoc HD3 User manual

1 2
3
Align the connecon hooks and slide
into place for all four panels
Secure the panels at the
boom with 4 screws
applied internally
Place the boom
panel and secure with 8
screws
Screw in all 6 feet. 4
in the corners and 2
in the middle
Secure the panels at
the top with 4 screws
applied internally
Turn the stand
upside down
Package includes:
- 4 panels
- 1 boom panel
- 8 screws for the boom
- 6 feet
- 2 screws for securing the display on
top of the stand
- Umbraco key
- 8 wing nuts + bolt
- 4 Plasc screw rivet
- 2 Steel rods
Assembling the HD3 stand

Insert two bolts in the front
and secure with bolts. Place the
Dreamoc on top of the display.
For support please visit
www.realcon.com/support/dreamoc-hd3.2-support
Realcon and Dreamoc are registered trademarks owned by Realcon ApS.
Other marks may be menoned here in that belong to other companies. ©
2019 Realfcion Aps. All rights reserved.
For further informaon and pricing please contact Realcon
Phone: [phone]
email: contact@realcon.com
It is very important to lock the HD3 display to the stand, and place a lot of weight
at the boom of the stand, in high trac areas.
Locking the HD3 to the stand
Remove the HD3 from the
stand and turn it around, so
the plate with the hole for the
vesa mount is at the front.
Remove both back
plates and the center
stage
Insert the steels rods into the
plasc base of HD3 and push the
steel as far as possible into the
HD3 plasc base.
Insert the 2 plasc screw rivets
inside the stand in the 2 holes
close to the front corners. Make
sure that the plasc screw rivets
are going through both the holes
in the stand close to the front
corners and the holes in the front
boom of HD3, so the front of
HD3 will be locked to the stand.
Slide the HD3 down on top of the
stand, so the steel rods will lock
the back of the HD3 to the stand.
Place the center stage and
back plates in the display
again.