Insert two bolts in the front
and secure with bolts. Place the
Dreamoc on top of the display.
For support please visit
www.realcon.com/support/dreamoc-hd3.2-support
Realcon and Dreamoc are registered trademarks owned by Realcon ApS.
Other marks may be menoned here in that belong to other companies. ©
2019 Realfcion Aps. All rights reserved.
For further informaon and pricing please contact Realcon
Phone: +45 70 20 64 90
email: contact@realcon.com
It is very important to lock the HD3 display to the stand, and place a lot of weight
at the boom of the stand, in high trac areas.
Locking the HD3 to the stand
Remove the HD3 from the
stand and turn it around, so
the plate with the hole for the
vesa mount is at the front.
Remove both back
plates and the center
stage
Insert the steels rods into the
plasc base of HD3 and push the
steel as far as possible into the
HD3 plasc base.
Insert the 2 plasc screw rivets
inside the stand in the 2 holes
close to the front corners. Make
sure that the plasc screw rivets
are going through both the holes
in the stand close to the front
corners and the holes in the front
boom of HD3, so the front of
HD3 will be locked to the stand.
Slide the HD3 down on top of the
stand, so the steel rods will lock
the back of the HD3 to the stand.
Place the center stage and
back plates in the display
again.
