Rear view safety RVS-6137-RCA User manual

Instruction Manual
Rear View Safety, Inc. © 2018
7" LED Digital Color Rear View Monitor with
RCA Connections
RVS-6137-RCA

Rear View Safety
2
SystemDescription............................3
SafetyBasics..............................4
UsageBasics ..............................5
SafetyBasics.............................. 6
BeforeYouBegin.............................7
Monitor Bracket Installation. . . . . . . . . . . . . . . . . . . . . . 8 - 9
CableConnection........................... 10
NavigatingtheMenu.......................... 11
Troubleshooting........................... 12
Specifications........................... 13
Warranty............................. 14
Disclaimer......................... 15
TABLE OF CONTENTS

Reverse With Condence ™ 3
SYSTEM DESCRIPTION
Congratulations on purchasing this Rear View Backup Monitor!
With this manual you will be able to properly install and operate
this item.
One of our keystone monitors, the RVS--RCA is a high
quality " LED Digital Panel display and is equipped with auto-
dimming and a built-in speaker.
Back-lit buttons illuminate in the dark for easy use, and
optional distance grid lines can be adjusted based on camera
placement.
Conveniently switch between mirror and normal image for
any connected camera. The monitor features convenient RCA
connectors.

Rear View Safety
4
If you have questions about this product, contact:
Rear View Safety
1797 Atlantic Avenue
Brooklyn, NY 11233
Tel: [phone]
IN NO EVENT SHALL SELLER OR MANUFACTURER BE
LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
SAFETY BASICS USAGE

Reverse With Condence ™ 5
USAGE
IMPORTANT USAGE WARNING
The Rear View Camera System is designed to help the driver safely
detect people and/or objects helping to avoid damage or injury.
However, you the driver, must use it properly. Use of this system is not
a substitute for safe, proper or legal driving.
Never back up while looking at the monitor alone. You should always
check behind and around the vehicle when backing up, in the same
way as you would if the vehicle did not have the Rear View Camera
System. If you back up while looking only at the monitor, you may
cause damage or injury. Always back up slowly.
Rear View Camera Systems are not intended for use during extensive
back-up maneuvers or backing into cross traffic or pedestrianwalkways.
Please, always remember, the area displayed by the Rear View Camera
System is limited. It does not display the entire panorama that is behind
you.
PLEASE READTHE ENTIRE MANUAL AND FOLLOWTHE INSTRUCTIONS AND
WARNINGS CAREFULLY. FAILURE TO DO SO CAN CAUSE SERIOUS
DAMAGE AND/OR INJURY, INCLUDING LOSS OF LIFE. BE SURETO OBEY ALL
APPLICABLE LOCAL TRAFFIC AND MOTOR VEHICLE REGULATIONS AS IT
PERTAINS TO THIS PRODUCT. IMPROPER INSTALLATION WILL VOID
MANUFACTURER’S WARRANTY.
!
USAGE BASICS

Rear View Safety
6
SAFETY INFORMATION
Make sure to firmly affix the product before use.
!
Affix
!
Smoke
Cover Cable
Wire
Reverse
Distractions
Obstructions
Dropping Unit
Where the power cable may touch a metal case,
cover the cable with a friction tape. A short circuit
or disconnected wire may cause a fire.
!
If smoke or a burning smell is detected, disconnect
the system immediately.
The Rear View System should only be used when
the vehicle is in reverse.
While installing be careful with the wire
positioning in order to avoid wire damage.
Do not watch movies or operate the monitor
while driving; as it may cause an accident.
Do not install the monitor where it may obstruct
drivers view or obstruct an air bag device.
Dropping the unit may cause possible
mechanical failure.
!
!
!
!
!
SAFETY BASICS

Reverse With Condence ™ 7
BEFORE DRILLING
Please check that no cable or wiring is on the other side of the
wall. Please clamp all wires securely to reduce the possibility
of them being damaged while vehicle is in use. Keep all cables
away from hot or moving parts and electrical noisy components.
We recommend doing a benchmark test before installation
to insure that all components are working properly.
CABLE INSTALLATION
Step :
Be sure to position the cable properly. Rear View Safety cables use
aircraft grade connectors which means the cable can be exposed
to all weather elements. Do not run the cable over sharp edges, do
not kink the cable and keep away from HOT and rotating parts.
Step :
Fasten all cables and secure all excess cable.
MONITOR INSTALLATION
Step :
To Attach the Pedestal mount to the dashboard or to the headliner
use self-tapping screws and/or the adhesive pad.
Step :
Attach monitor to mount, and adjust mounting angle to allow
optimum driver viewing comfort. (See figure 1.1 on page 8)
BEFORE YOU BEGIN

Rear View Safety
8
MONITOR DIAGRAM
Figure . Figure .
Figure . Figure .
Installation of
U Bracket
Installation of
Flushmount Bracket
MONITOR BRACKET INSTALLATION

Reverse With Condence ™ 9
Step ) Put sunshield cover on
the display.
Step ) Put the monitor with
sunshield cover in the back
cover (only for embedded
monitor)
Hold monitor with  hands and detach
with fingers, as indicated by arrows.
(only for embedded monitor)
Take the monitor with the left
hand and detach with right
hand as indicated by the
white arrow. (See image)
SUNSHIELD
MONITOR
MONITOR
INSTALLING SUNSHIELD
SPLITTING BACK COVER
SUNSHIELD
SPLITTING SUNSHIELD
SUNSHIELD
MONITOR
BACK
COVER

Rear View Safety
10
Camera
(Sold Separately)
Power
Video 
Video 
Audio 
Monitor
Yellow to Video 2
INSTALLING MONITOR
GND
Back
Audio 
Power
CABLE CONNECTION

Reverse With Condence ™ 11
MONITOR OPERATIONS
• "Brightness" "Contrast "Saturation" "Sharpness": adjust image properties
• Picture Adjust: Stretch image horizontally (right/left and left/right)
• Turn: Toggle between mirror/normal image on each individual channel
• Day/Night: Toggle between back-lit buttons and auto dimming
• Name: Change name of each individual channel
• Trigger source: Toggle channel destination for each trigger
• Distance Grid: Toggle which channel distance grid lines will display on
• Grid Position: Adjust grid lines
• Reset: Reset to default factory settings
• Auto Power Options
- On: Monitor will automatically turn on when powered.
- Off: Monitor will only turn on when triggered.
- Auto: Monitor will follow previous state.
CAMERA
SELECTION
MENU/
SELECTION
BUTTON
POWER
ON/OFF
DOWN
ARROW
UP
ARROW
ROTATE
IMAGE
(Exit in Menu
Mode)
NAVIGATING MENU
MENU DESCRIPTIONS
NAVIGATING THE MENU

Rear View Safety
12
TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM SOLUTION
Monitor Displays
Blue Screen
(and/or) No
Signal Display
 Do a hard reset, unplug all cables leave out for
 minute and then re-connect them
 Check to ensure that the connection to the
camera is tight.
 Verify camera cable is plugged into port labeled
Backup Camera
 Verify that the blue positive trigger on power
harness is put to power v+
If problem persists, verify that alternate ports
work. If alternate ports do not work, remove
Blue Trigger wire from 12V+ and select alternate
channel.
Monitor Will
Not Power-Up
(no backlight on
power button)
• Check fuse
• Check v+ to monitor
 Check ground connection
No Image
on Screen
• Verify camera is on correct camera input
 Verify cable is connected to monitor
• Verify camera is connected to cable
• Connect known working camera & cable to
monitor
• Verify Blue trigger is receiving power
No Audio
from Camera
• Verify chosen camera has audio
• Verify volume setting

Reverse With Condence ™ 13
SPECIFICATIONS
Type LED Digital Panel
Screen Size "
Dot Resolution  X  (RGB) X 
Display Format :
Contrast :
Display Brightness  CDm
Viewing Angle Up: ° / Down: °
Left: ° / Right: °
Video Input  Channels
Video Source VPP, Ω
Power Supply DC V – V
Power Consumption W
Audio Output .W speaker
Operating Temperature -°C ~ +° C
Storage Temperature -°C ~ +°C
Video System Auto Auto NTSC/PAL
Overall Dimensions " L X ." H X " D
Weight G
Vibration Rating G
Dot Pitch . H X . VMM
Active Area .(H) X .(v)mm
Sync System Internal
MONITOR SPECIFICATIONS

Rear View Safety
14
ONE YEAR WARRANTY
REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A
PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR
REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC.
IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER
INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW
SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND.
THIS WARRANTY IS VOID IF: DEFECTS IN MATERIALS OR WORKMANSHIP OR DAMAGES
RESULT FROM REPAIRS OR ALTERATIONS WHICH HAVE BEEN MADE OR ATTEMPTED BY
OTHERS OR THE UNAUTHORIZED USE OF NONCONFORMING PARTS; THE DAMAGE IS DUE
TO NORMAL WEAR AND TEAR, THIS DAMAGE IS DUE TO ABUSE, IMPROPER MAINTENANCE,
NEGLECT OR ACCIDENT; OR THE DAMAGE IS DUE TO USE OF THE REAR VIEW SAFETY, INC.
SYSTEM AFTER PARTIAL FAILURE OR USEWITH IMPROPER ACCESSORIES.
WARRANTY PERFORMANCE
DURING THE ABOVEWARRANTY PERIOD, SHOULD YOUR REAR VIEW SAFETY PRODUCT
EXHIBIT A DEFECT IN MATERIAL ORWORKMANSHIP, SUCH DEFECTWILL BE REPAIREDWHEN
THE COMPLETE REAR VIEW SAFETY, INC. PRODUCT IS RETURNED, POSTAGE PREPAID AND
INSURED, TO REARVIEW SAFETY, INC. OTHERTHAN THE POSTAGE AND INSURANCE
REQUIREMENT, NO CHARGEWILL BE MADE FOR REPAIRS COVERED BY THIS WARRANTY.
WARRANTY DISCLAIMERS
NOWARRANTY, ORAL ORWRITTEN, EXPRESSED OR IMPLIED, OTHERTHE ABOVEWARRANTY
IS MADEWITH REGARDTOTHIS REARVIEW SAFETY, INC.REARVIEW SAFETY, INC.DISCLAIMS
ANY IMPLIED WARRANTY OR MERCHANT-ABILITY OR FITNESS FOR A PARTICULAR USE OR
PURPOSE AND ALL OTHER WARRANTIES IN NO EVENT SHALL REAR VIEW SAFETY. INC.
LIABLE FOR ANY INCIDENTAL, SPECIAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES OR FOR
ANY COSTS, ATTORNEY FEES, EXPENSES, LOSSES OR DELAYS ALLEGEDTO BE AS A
CONSEQUENCE OF ANY DAMAGE TO, FAILURE OF, OR DEFECT IN ANY PRODUCT INCLUDING,
BUT NOT LIMITED TO, ANY CLAIMS FOR LOSS OF PROFITS.
WARRANTY

Reverse With Condence ™ 15
DISCLAIMER
REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE
USER OF OUR SYSTEMSWILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE
WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL
AND CAUTIOUS DRIVING OR FORTHE CONSISTENT ADHERENCE TO ALL APPLICABLETRAFFIC
LAWS AND MOTOR VEHICLE SAFETY REGULATIONS.THE REAR VIEW SAFETY PRODUCTS ARE
NOT A SUBSTITUTE FOR REARVIEW MIRRORS OR FOR ANY OTHER MOTOR VEHICLE
EQUIPMENT MANDATED BY LAW. OUR CAMERA SYSTEMS HAVE A LIMITED FIELD OF VISION
AND DO NOT PROVIDE A COMPREHENSIVEVIEW OFTHE REAR OR SIDE AREA OFTHEVEHICLE.
ALWAYS MAKE SURETO LOOK AROUNDYOURVEHICLE AND USEYOUR MIRRORSTO CONFIRM
REARWARD CLEARANCE AND THAT YOUR VEHICLE CAN MANEUVER SAFELY. REARVIEW
SAFETY AND/OR ITS AFFILIATES SHALL HAVE NO RESPONSIBILITY OR LIABILITY
FOR DAMAGE AND/OR INJURY RESULTING FROM ACCIDENTS OCCURRING WITH VEHICLES
HAVING SOME OF REAR VIEW SAFETY PRODUCTS INSTALLED AND REAR VIEW SAFETY AND/
OR ITS AFFILIATES, THE MANUFACTURER, DISTRIBUTOR AND SELLER SHALL NOT BE LIABLE
FOR ANY INJURY, LOSS OR DAMAGE, INCIDENTAL OR CONSEQUENTIAL, ARISING OUT OFTHE
USE OR INTENDED USE OF THE PRODUCT. IN NO EVENT SHALL REAR VIEW SAFETY AND/OR
ITS AFFILIATES HAVE ANY LIABILITY FOR ANY LOSSES (WHETHER DIRECT OR INDIRECT, IN
CONTRACT,TORT OR OTHERWISE) INCURRED IN CONNECTION WITH THE SYSTEMS,
INCLUDING BUT NOT LIMITEDTO DAMAGED PROPERTY, PERSONAL INJURY AND/OR LOSS OF
LIFE. NEITHER SHALL REAR VIEW SAFETY AND/OR ITS AFFILIATES HAVE ANY
RESPONSIBILITY FOR ANY DECISION, ACTION OR INACTION TAKEN BY ANY PERSON IN
RELIANCE ON REAR VIEW SAFETY SYSTEMS, OR FOR ANY DELAYS, INACCURACIES AND/OR
ERRORS IN CONNECTIONWITH OUR SYSTEMS FUNCTIONS.
DISCLAIMER

If you have any questions
about this product, contact:
Rear View Safety, Inc.
1797 Atlantic Avenue
Brooklyn, NY 11233
800.764.1028
Better Cameras. Better Service.
IT’S OUR GUARANTEE.