Renew REN Series User manual

1
Wire Shelf Cover
REN-**
REN-I

2
Parts List
A B C1 1 1
D E5 4 F4G4
H2I2
Hardware List
K4
2.5 in. Rail 1 in. Rail
Panel Clip Spacer Nut
1.75 in. End Cap 2.5 in. End Cap
5/8in. Screw L43/8in. Screw
Required Tools
Screw Driver
Thank you for your purchase. For any product or installation questions, damages, replacement or missing parts please contact us at:
1.800.480.6985
[email protected]
www.johnlouishome.com
1.75 in. Rail

3
E EF GGK L
Step 2 - Attach mounting hardware to rail.
Hardware used for shelving with wall end attachment.
Loosely assemble hardware.
Hardware used for shelving without wall end attachment.
Loosely assemble hardware.
A
B
C1 in. Rail
(Used if hanger
clearance is
required)
1.75 in. Rail
2.5 in. Rail
Step 1 - Select your rail size.

4
Step 2 - Attach mounting hardware to rail (cont.).
Insert assembled hardware into lower rail channel. Position hardware evenly on rail positioned at open
spaces on wire shelf front.
Align clip towards upper rail channel. Secure hard-
ware with screwdriver.

5
Step 3 - Assemble panels & front rail.
Determine your shelf depth and the amount of panels required.
Insert rst panel into the upper channel on the front
rail.
Attach the remaining panels by sliding each one
together.
20 in. Depth Shelf - 5 Panels
16 in. Depth Shelf - 4 Panels
12 in. Depth Shelf - 3 Panels
D
D
D
D
D

6
Step 3 - Assemble panels & front rail (cont.).
Attach end cap to both front rail ends. NOTE: If adding another shelf cover next to existing shelf cover, do
not attach end cap at end where new shelf cover butts up to.
No End Caps Used
/
H I
Step 4 - Attaching to wire shelf.
Place wire shelf cover onto wire shelf.

7
Step 4 - Attaching to wire shelf (cont.).
Ensure clips are attached to the front/top of wire shelf and bend clips to secure. NOTE: In some instances
the clip will be tight depending on wire shelf thickness and type.
Cutting Wire Shelf Covers (If required) - In some cases your shelf length may not equal round mea-
surements. For example your shelf is 3ft. 8in.. In this case your shelf cover will require cutting.
Measure wire shelf. Mark measurement on each
panel and shelf rail to be used.
Cut each item independently.
Chop Saw with ne tooth blade is recommended

8
Installing Corners - Installing corners require the cutting of 1 interior corner rail.
Step 1 - Place required panels into the corner on
1st shelf.
Step 2 - Follow normal installation steps for the
shelf cover on 2nd shelf ensuring cover is ush with
panels on 1st shelf.
Step 3 - Measure the distance between the front
rail face on the 2nd shelf cover and the end of the
panels on the 1st shelf.
Step 4 - Mark the measurement on the front rail for
the 1st shelf and cut.
TOP VIEW TOP VIEW
TOP VIEW

9
Installing Corners (cont.).
Step 5 - Install rail hardware and attach the rail to
shelf panels.
Step 6 - Ensure the 1st shelf rail is ush with the rail
face of the 2nd shelf and secure. Repeat the normal
installation procedure for any remaining shelf dis-
tances to cover.
TOP VIEW TOP VIEW