REPTILE CS-8759 User manual

Reptile Basics, Inc
CS-8759 6qt Shoebox Rack
Assembly Instructions
Order tubs from:
www.reptiletubs.com
Model # 8759
Parts List:
1. Back - Marked "B” On one side and “A" on
the other. Heat tape is installed.
2. Right Side - Marked "A Top"
3. Left Side - Marked "B Top"
4. Top Shelf- no holes for locking pins.
4. 8pcs Shelves- These have holes for locking
pins.
5. Stacking Bar (Used To Stack Racks)
6. Screw
7. White Locking Pins
8. Aluminum Tape
1. Identify the parts listed above and lay them
out. Set the Top Panel aside. It will be the last
piece to be installed.
2. Locate the back panel (A Top B) (1) and the
Right panel (A Top)(2) and align using arrows
and alignment tabs and slots. (Fig. 11&12)
Note that the Text will be on the inside of the
rack and not visible once assembly is
complete. Make sure each tab is fully aligned
in the Slot, then drive screws in through the
pre drilled holes.( Fig. 13,14) *Do Not Over
Tighten* Screw Head should be flush with
outer surface when fully tightened. It will be
self Recessing.
3. Locate the Left panel (B Top)(3) and align
again using arrows and Tab/Slot. Secure with
screws. (Fig. 15)

White pins are used as shown to prevent tubs
from accidentally moving forward.(Fig.19)
Stacking bars are used as shown when
stacking racks. (Fig. 20)
5. Slide a shelf panel into bottom slot. Make
sure that it slides fully into the slots in the back
panel. The front of the shelf should be flush
with the front edge of the side panels. (Fig, 16)
Pull the shelf forward slightly if needed.
Install a screw through each predrilled hole in
sides A and B, being careful not to over tighten
and you are ready to install the next shelf.
6. At this point you can continue assembly
with the rack on it's back, installing each shelf
the same as the first. Install the top by sliding
into place and fastening with screws, the same
as the shelves. Then stand it upright (Fig. 17)
and install screws into the back of the rack.
.
8.Probe placement: Pass the thermostat probe
through the hole in the back panel and using
the aluminum tape affix as shown.(Fig.18)