Installation and Operation manual
Tilt the Pole® –Version 3
TTP-V3
Resort Umbrella Solutions | www.resort-umbrella-
solutions.com | www.tiltthepole.com
Step 10
Install lower post into TTP-V3
Take the lower post and install it into
the TTP-V3. It will come to a stop
inside.
Line up the hole of the 2 posts.
Insert 10-32 screw –it will go all the
way through.
Thread the wing nut onto the screw
so that you completely thread the
screw-make a secure tight fit but do
not over-tighten. The wing nut is
used so that the TTP and umbrella can
be removed easily. If preferred you
can use a nylock nut instead of a wing
nut.
The current TTP-V3 model is designed for
umbrellas with 1.5” diameter poles. Use only
umbrella manufacturers approved by Resort
Umbrella Solutions. Warranty can be voided.
