U-Line H-4455 User manual

PAGE 1 OF 2 1213 IH-4455
πH-4455
MOBILE BLUEPRINT RACK
1-800-295-5510
uline.com
1. Position Frame Extension with holes toward the floor.
Insert Frame Extension into the short end of the Side
Frame tubes. (See Figure 1)
2. Slide posts of Upper Rack into the long end of the
Side Frame tubes. (See Figure 1)
3. Install Casters to underside of frame by carefully
screwing them in. Position both Locking Casters at
the rear of the frame, closest to the Upper Rack.
(See Figure 1)
4. Insert End Caps into the Upper Rack. (See Figure 1)
5. Insert Set Screws into Side Frames at four locations.
Adjust to desired height and depth by using set
screws and Allen wrench to lock in position.
(See Figure 1)
6. Attach Lower Spreader Bar to Side Frames using two
1/4-20 x 3" Bolt and Washers. Fully tighten screws to
secure bar in position. (See Figure 1)
Set Screw
ASSEMBLY INSTRUCTIONS
PARTS
Allen Wrench (Included)11mm Wrench
TOOLS NEEDED
Upper Rack x 1 Lower Spreader
Bar x 1
Side Frame x 2 Frame
Extension x 1
Pivot Hanger x 12 Swivel
Caster x 2
Locking Swivel
Caster x 2
Washer x 2
Set Screw x 4
1/4 - 20 x 3"
Bolt x 2
End Cap x 2
Figure 1

PAGE 2 OF 2 1213 IH-4455
ATTACHING THE PIVOT HANGERS
7. Attach pivot hangers to frame by inserting spring-
loaded top post into top hole of Upper Rack,
then inserting bottom post into bottom hole.
(See Figures 2-4)
Spring-Loaded
Top Post
ASSEMBLY INSTRUCTIONS CONTINUED
Pivot Hanger
Figure 2
Figure 3
Figure 4
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com