Racking Solutions HST003 User manual

Chrome 3 Tier Heavyduty Rack
HST003
PACKAGE CONTENTS
Please inspect box contents to ensure you have received all components.
Note: the black circular plastic tops in between the shelves are used only for
packaging purposes. They are NOT NEEDED. Please discard responsibly &
keep away from small children.
Each shelf holds up to 275kg with equal weight distribution on
Total weight capacity of shelving rack is 825 kg on feet levelers.
leveling feet.
CX24+2
AX3 BX4
Shelf Pole ( with end cap, threaded insert
and feet leveler pre -installed)
extra Slip sleeve
DX4
Feet Leveler
HELP LINE
01977 555007
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
Never climb or stand on the shelves.
Informa on
if in doubt contact the supplier
Allow adequate working space and be
aware of others working around you
Inspect all packages for damage and
check that all components have been
supplied
Cau on
During Assembly
!
Warning
Rules for safe use of shelving
!
ENSURE THAT THE MAXIMUM LOAD
CARRYING CAPACITIES ARE NOT
EXCEEDED
Dispose of packaging materials
responsibly
Wear appropriate clothing -protec ve
gloves and footwear are
recommended
Make sure the floor is level
Take care when handling heavy items
par cularly when li ing or stretching
Please read these instruc ons
throughly before commencing
assembly.
Assembly should be undertaken by
at least two people
Not suitable for use in damp or wet
environments.
Shelves must be loaded evenly, and load
heavier items on the bo om shelves
Rubber Mallet

ASSEMBLY INSTRUCTIONS
STEP 1: SLIP SLEEVES
On the Pole (B), place 1 pair of slip sleeves (C) at the desired level.
Please make sure the arrow faces up and that the word “top” is right
side up. Do this for each Pole (B) and make sure that the heights are
identical for Pole (B)
Slide the pair of Slip Sleeves (C) until you hear a click to confirm the
pair is locked onto the Pole (B).Do not place more than one pair on
each Pole (B) at a time.
*For safety and stability, the lowest SHELF (A) should be lower than
the 3rd notch from the bottom.
**Note: There will be a very small gap in- between the Slip Sleeves
(C) -this is normal.
STEP 2 : INSTALLING BOTTOM SHELF
Place Shelf (A) on its side and slide the Pole (B) through the holes in
the Shelf (A ). Make sure that the shelf (A) corner cylinders are
positioned over the Slip sleeves (C).
Stand the unit upright.
*Note : The level side of the Shelf (A) is the Top side(the logo on the
corner cylinders should be right -side up.)
**Use a rubber mallet, if needed, to secure the Shelf (A).
STEP 3: INSTALLING REMAINNING SHELVES
Repeat step 1 & step 2 to install remaining Shelves (A) as desired.
B
C
A
A
B
STEP 4: FEET LEVELERS
The Feet Levelers are already screwed into the Pole (B)
and you can adjust as needed to ensure your Shelving
Rack is level.
STEP 5: FINISH
AND ENJOY YOUR QUALITY
RACKING SOLUTION PRODUCT
B
D
A
A