Temporarily set aside the paddle springs. Then remove the 2
screws securing the paddles to the pivots.
Insert the pre-assembled paddle into the slot and secure to
the original plastic pivot with the 2 original screws. Repeat
the last 3 steps on the other side.
Re-assemble internal paddle spring retainers as shown.
Replace the cover onto the housing and secure with the 4
original screws.
Plug the quick-release into the plug of the internal circuit
board and place the quick-release into the rear housing.
Mount the steering wheel or your Ricmotech wheel adapter
to the front to secure the quick-release into place.
The paddles have 2 mounting positions on the mounting tabs.
The narrower position is suitable for 320mm to 340mm
wheel rims, while the wider position is good for 340mm or
larger wheel rims.
Need Help?
If you run into any problems during the installation of the
paddles, please contact us directly at technical support at
(305) 417-9241 or via email at mail@ricmotech.com.
Due to constant improvements to our products, the product
you receive may vary slightly from the product shown in the
illustrations.
Copyright 2016, Ricmotech LLC
Thrustmaster® is a trademark of the Guillemot® company and
the terms are used for reference purposes only. Ricmotech
LLC is not affiliated with Thrustmaster®.
