1.1. Products Covered
The manual applies to devices of ELC series and PR series
only. For more information about EXM series (GSM and WIFI
module), please refer to the x-Messenger User Manual
1.2. Product Safety
This manual contains notices you have to observe to ensure
your personal safety, as well as to prevent damage to property.
The notices referring to your personal safety are highlighted in
the manual by a safety alert symbol; notices referring to
property damage only, have no safety alert symbol. The notices
shown below are graded according to the degree of danger.
Table 1 - Safety Warnings
Symbol Hazard Description
Indicates that death, severe personal injury
or damage to assets will result if proper
precautions are not taken.
Indicates that death, severe personal injury
or damage to assets may result if proper
precautions are not taken.
Indicates personal injury or damage to
assets can result if proper precautions are
not taken.
Indicates that an unintended result or
situation may occur if the corresponding
notice is not taken.
NOTICE:
If more than one warning is present, then the warning
with the highest degree of danger shall be used.
1.3. Qualified Personnel
Only persons qualified to correct electrical and safety standards
and regulations at the time of use should be allowed to install,
commission and operate this equipment.
The device/system may only be set up and used in conjunction
with this documentation. Commissioning and operation of a
device/system may only be performed by qualified personnel.
Within the context of the safety notices in this documentation
qualified persons are defined as persons who are authorized to
commission, ground and label devices, systems and circuits in
accordance with established safety practices and standards.
Please read the complete operating instructions before
installation and commissioning. Rievtech or its distributors does
not accept any liability for possible damage to persons,
buildings or machines, which occur due to incorrect use or from
not following this manual.
1.4. Trademarks
All names identified by xLogic are registered trademarks of the
Rievtech. The remaining trademarks in this publication may be
trademarks whose use by third parties for their own purposes
could violate the rights of the owner.
1.5. Copyright Rievtech 2015 all rights
reserved
The distribution and duplication of this document or the
utilization and transmission of its contents are not permitted
without express written permission. Offenders will be liable for
damages. All rights, including rights created by patent grant or
registration of a utility model or design, are reserved.
1.6. Disclaim of Liability
We have reviewed the contents of this publication to ensure
consistency with the hardware and software described. Since
variance cannot be precluded entirely, we cannot guarantee full
consistency. However, the information in this publication is
reviewed regularly and any necessary corrections are included
in subsequent editions.
1.7. Additional support
We take pride in answering your question as soon as we can.
Please consult our website at www.rievtech.com for your
closest point of contact or email us at sales@rievtech.com.
