6
Step 7
12. Lay your Flash Heater onto a smooth surface
so not to scratch the black surface of the
heating element.
13. Locate the Top Bracket, ¼”-20 Hex-Bolt, Black
Handle and (6) 1-3/4” self-tapping Screws.
14. Insert the ¼”-20 Hex-Bolt thru the hole in the
Mounting Bracket. Thread the Black Handle
onto the Bolt, securing it tightly.
15. Aach the Top Bracket your Flash Heater using
the (6) 1-3/4” self-tapping Screws. Thread the
Screws into the pre-punched holes on the top
panel of your Flash. Tighten the Screw snuggly,
while careful not to overtighten pulling screw
threads thru sheet metal.
STEP 8
• (It may be helpful to rest your Flash Heater on a table for this step of aaching the Upper
Tube)
16. Locate (2) of the Level Adjustment Knobs and the (2) Spacing Collars.
17. Slide each of the Collars onto threads of the Adjustment Knobs.
18. Insert the curved plate welded to the
Upper Tube between the Top Bracket and
your Flash Heater.
19. Align the First Set of Threaded Holes of the
Upper Tube with the thru holes on the Top
Bracket.
20.Thread the Adjustment Knobs with Spacing
Collars thru the Upper Bracket into the
Threaded Holes.
21. Locate the remaining Leveling Adjustment
Knob.
22.Thread the Knob into the Insert Nut on the
Top Mounting bracket.
23.Locate the Height Adjustment Collar and
Bent Bolt.
24.Slide the Height Adjustment Collar onto
the Upper Tube.
25.Using the Bent Bolt as a set screw, tighten
onto the Upper Tube.
Top bracket
1 ¾” Screws¼-20
Hex bolt
Flash
heater
Black handle
Level adjustment knobs
Insert nut
Spacing
collars
First
set of
threaded
holes
Upper tube
Height adjustment collar
Set bolt
