
FCC Compliance Statement (USA)
This device (including related accessories like the adapter) complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The party responsible for FCC compliance is Ring LLC
1523 26th Street Santa Monica, CA 90404
To contact Ring about the device’s FCC equipment authorization, please write us at the address
Device Name: Ring Indoor Cam
Model:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
WARNING: Pursuant to Section 15.21 of the FCC rules, changes or modifications to this device by the
user that are not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Additional information regarding the Ring Indoor Cam FCC equipment authorization(s) can be
found at: ring.com/regulatory
RADIO FREQUENCY EXPOSURE CAUTION:
The output power of the radio technology used in the device is below the radio frequency
exposure limits set by the FCC. Nevertheless, it is advised to use the device in such a manner
that minimizes the potential for human contact during normal operation.