RIO ADVENTURE RA-i456 Manual

Set-up Instructions for RIO Adventure Compact Expandable Table
STEP 1: Be sure you have
one (1) frame and two (2)
table tops, as shown.
STEP 4: Extend the telescoping table leg.
Use nut to loosen and tighten. Adjust to
ground slope after table is set up. Please
note there is one (1) adjustable
telescoping leg.
STEP 3: Press the buttons to
extend the other three (3)
telescopic table legs. Legs will
snap once in fully-extended
position.
STEP 2: Unfold legs
so feet point down
toward the floor.
STEP 5: Splay the frame open.
STEP 6: Lock all four (4) corner braces.
STEP 7: Open the
LARGER of the two
table tops.
STEP 8: Begin unrolling
the table top slats at one
end of the frame until it
completely flat.
STEP 9: Fold the end
slats over each end and
secure by sliding the
nubs through the holes.
To use the 27.5” x 28.5” table top only
RA-i456 Rev 12/2010
www.IntegrityOutdoorBrands.com
STEP 10: Attach the two
hook-n-loop tabs on the
undersides of the table.
To attach a handled trash bag:
Locate the hook-n-loop straps on one side of the table top. Be sure they are centered
in between the nubs (they slide easily into place). Thread each hook-n-loop strap
through each of the bag handles (shown in Figure 1) and reattach the straps on the
underside of the table top (shown in Figure 2).
Figure 1 Figure 2
See other side for instructions on how to create a 48” x 27.5” table.

2
Follow STEPS 1 through
4. Use the nylon loops to
pull and extend the frame
until it stops sliding.
Set-up Instructions for RIO Adventure Compact Expandable Table (continued)
STEP 6: Unroll both table tops
onto the frame. Match the table
top letters (A or B), found
under the slats, to the
corresponding frame letters (A
or B) as shown in Figure 3,
right.
STEP 7: Marry the table
tops using the rivets
and sockets.
TO FOLD AND STORE:
• Follow steps in reverse order.
• Wrap the closure straps around table
top sections and secure with hook-n-
loop.
• Place contents into carry bag.
STEP 9: Attach the two
hook-n-loop tabs on the
undersides of the table.
RA-i456 Rev 12/2010
www.IntegrityOutdoorBrands.com
Please note: To create a 48” x 27.5” table from a 28.5” x 27.5” table, you must FIRST remove the 28.5” x 27.5
table top.
Large table
top section Small table
top section
Figure 3
A
A
B
B
B
STEP 5: Splay open the frame and lock
all four corner braces.
STEP 8: Fold the end
slats over each end and
secure by sliding the
nubs through the holes.