Rixen Digital Heating Thermostat User manual

Rixen Digital Heating Thermostat
Manual v1
User interface:
Only light pressure is needed to operate the 3 buttons. Display will dim after 15 seconds, tap
any of the 3 buttons to return to full illumination.
1. When the Heater is switched OFF
2. When Heater is switched ON
(and set temp is above room temp i.e heater running)
3. When Heater is switched ON
(and set temp is below room temp, i.e. heater on standby)
4. Setup Programming options:
a. Set display to Fahrenheit or Celsius
b. Temperature sensor select:
Internal (default) or
External Sensor (Note: external sensor needs to be ordered separately)
n/a
n/a
Heater On/Off
Room temperature
Heater status=Off
Set Temp up
Heater On/Off
Set Temp
down
Room temperature
Set temperature display
Heater running indicator
Heater standby indicator
Room temperature
Set temperature display
Heater On/Off
Set Temp up
Set Temp
down
To enter programming mode:
Hold the On/Off button until the display appears.
To toggle between Internal and external sensor tap
the up arrow (only one sensor active at a time).
To toggle between Fahrenheit and Celsius tap the
down arrow.
To leave programming mode tap the On/Off button.
Internal temp sensor location

Wiring:
Red 12VDC + (install fuse - not supplied - 10A)
Black Ground
Yellow Switched Output 12VDC max 5A
2x Blue External temperature probe (no polarity),
sensor is optional, insulate wires when not used
Specs:
Operating Voltage: 10V - 16V
Power consumption: 19mA max, 10mA standby (@ 12.3V)
Mounting:
2x pems, drill 1/4” or 6mm holes
Cable hole 1/2” or 13mm
Dimension:
87mm (W) x 70mm (H) x 13mm (H)
Mounting template:
Print template - verify that your printer did not scale the drawing
Rixen Digital Heating Thermostat
Manual v1
6mm or 1/4” drill bit
6mm or 1/4” drill bit
13mm or 1/2” drill bit