RNIB CC36 User manual

1
RNIB Talking Cube Clock
CC36, CC37 & CC42
Please retain these instructions for future reference.
Contents
General description..........................................................................................1
Orientation and controls...............................................................................2
Setting the volume .......................................................................................2
Setting procedures.......................................................................................2
Switching the hourly time announcement on or off.......................................2
Setting the alarm..........................................................................................3
Alarm am/pm setting....................................................................................3
Choosing the alarm sound ...........................................................................3
Alarm reminder.............................................................................................4
Setting the current time................................................................................4
Clock am/pm setting.....................................................................................4
Inserting/Replacing Batteries .......................................................................5
Care and Maintenance.................................................................................5
Terms and Conditions of Sale..........................................................................6
Product Regulations.....................................................................................7
Keep up-to-date with new products from RNIB............................................. 8
General description
It is recommended that you read the following instructions in their entirety
before you attempt to use this clock.
The Talking Cube Clock has an English, male voice and a number of other
audible cues to help the user.
It also has the following features: current time announcement, adjustable
volume, an hourly time announcement, which you can switch on or off as
required, a 12-hour clock and an alarm facility with a reminder function.

2
The clock is cube-shaped with rounded corners. The speaker grill is at the
front and the large time announcement button is on the top of the unit.
At the back of the clock there are two smaller buttons and a rotary volume
control.
Please note: The clock is supplied with 4 × AA batteries, which are packed in
with the product. Please see below for instructions on how to insert.
Orientation and controls
With the large circular button on the top and the speaker grill facing away from
you, the main controls are to be found underneath the back cover. The square-
shaped button on the left is the "mode" button and the circular button on the
right is the "set" button. Also at the back of the clock, in the centre, there is the
rotary volume control which is used to adjust the volume of the speech and
other sounds from the clock's speaker.
Setting the volume
You should use the time announcement button at the top in conjunction with
the rotary volume control to verify and adjust the volume level.
Setting procedures
At the back of the clock, underneath the back cover are two buttons. These are
used to set up the clock. The square mode button on the left is used to cycle
through the various clock functions.
Each of the functions will now be described in turn, following the order in which
they will be found when you start using the clock for the first time.
Switching the hourly time announcement on or off
After pressing the mode button (on the left), once, the unit will say "announce
off". You can then press the circular button (on the right), once, and the clock
will say "announce on". When you press the button again, the clock will say
"announce off". At any time during set up you can press the large circular
button on top of the clock to return to current time announcement mode or you
can simply proceed to the next mode by pressing the square mode button
once more.

3
Setting the alarm
After pressing the mode button the clock now says, "alarm off". Alter this, if
desired, to "alarm on" by pressing the small, circular set button on the right.
Move to the next setting by pressing the square mode button and the clock will
say "alarm hour" followed by the actual alarm hour setting (e.g. "alarm hour
6"). Change this by pressing the circular set button. The clock will announce
the alarm hours as you cycle through them.
Each time the set button is pressed the alarm hour value will advance by one,
and the unit will say "hour", followed by the hour you have reached.
In the next mode the clock announces "alarm minute" followed by the current
alarm minute setting. Advance this by using the set button in the same way as
for the alarm hours. Note: If the set button is held down for five consecutive
announcements the alarm minutes will be advanced in five minute blocks (five,
ten, and so on) until the button is released. The next time you press the set
button the alarm minute setting will again advance by one minute.
Alarm am/pm setting
The next mode announces "alarm" followed by the current alarm am/pm
setting. This controls whether the alarm goes off before or after noon at the
alarm time already set. Toggle this setting between am and pm by pressing the
set button. The new setting will be announced each time.
Choosing the alarm sound
In the next mode the clock says "alarm" followed by the currently selected
alarm sound. Cycle through the various alarm sounds available by pressing
the set button repeatedly. You can choose from the following list of alarm
sounds:
a two-tone alarm
a mechanical bell sound
a horn sound
a cuckoo and
a beeping alarm.

4
Alarm reminder
The clock's alarm will sound for one minute and then pause for four and a
quarter minutes. This process will be repeated five times and then stop, unless
you cancel it by pressing the large time announce button on the top of the
clock.
Setting the current time
In the next mode the clock says "clock hour" followed by the current clock hour
setting. Use the set button to advance the hours.
In the next mode the clock says "clock minute" and the current clock minute
setting. Advance this by using the set button. As with the alarm minute setting
procedure above, the clock minute setting can be speeded up by holding down
the set button for five announcements.
Clock am/pm setting
In the next mode the clock says "clock" then the current am/pm setting.
Change this by pressing the set button.
Pressing the mode button once more will return the clock to current time
announcement mode and can be used to confirm your time setting.
Special note
To confirm the alarm status, simply press the set button in the current time
announcement mode. The clock will announce the current alarm settings -
alarm sound, alarm on/off and the alarm time. This action will not change any
of the clock's settings.
The clock will keep time throughout the set up procedure described above and
the clock modes are listed in their order of appearance below: -
Current time announcement
Announce on/off
Alarm on/off
Alarm hour
Alarm minute

5
Alarm am/pm
Alarm sound
Clock hour
Clock minute
Clock am/pm.
Inserting/Replacing Batteries
The battery compartment is at the back in the lower half of the clock. Remove
the compartment cover by pressing the tab at the base, towards the middle of
the clock and lift the lid until it comes away completely. Remove the
detachable battery holder.
The four AA batteries should be inserted with their flat (negative) ends against
the springs in the battery holder. Make sure the batteries are fitted securely
and clip the detachable battery holder into the connector. Make sure that the
connector positive (+) and negative (−) are in the correct position/polarity with
the detachable battery holder.
Replace the battery compartment lid carefully by inserting the two tabs on the
lid into the recesses in the middle of the clock's case, press gently down on the
compartment lid until you hear the first click. Press down again until you hear
another click, which will indicate that the cover is securely in place.
Always remember to remove old or weak batteries as they can leak chemicals,
which can destroy the clock's electronic circuits.
Replacement AA batteries are available from RNIB under product code CP03.
The clock can also be used with rechargeable AA batteries, not currently
supplied by RNIB.
Do not ever use a mixture of rechargeable and non-rechargeable batteries in
this clock.
Please note: RNIB does not guarantee the life of batteries.
Care and Maintenance
This product must be disposed of in accordance with the WEEE Directive. The
Waste Electrical and Electronic Equipment Directive aims to minimise the
impact of electrical and electronic goods on the environment, by increasing re-
use and recycling and reducing the amount of WEEE going to landfill. It seeks
to achieve this by making producers responsible for financing the collection,

6
treatment, and recovery of waste electrical equipment, and by obliging
distributors to allow consumers to return their waste equipment free of charge.
To keep the clock in good working order for many years to come we
recommend you follow these simple instructions:
Keep the clock dry. If it does get wet, wipe it dry immediately as liquid might
contain minerals and corrode the electronics. Use and store the clock at a
normal temperature as temperature extremes shorten the life of electronic
devices, damage batteries, and can distort or melt plastic parts. Also, handle
the clock carefully as dropping it can cause damage and stop the clock
functioning properly.
In cases of difficulty when setting the clock, please note that it is possible to
restore the clock's default settings by removing the batteries and then
reinserting them. You can then recommence setting procedures.
Wherever possible, keep the clock away from dust and dirt, which can cause
premature wear of parts. Wipe the clock with a damp cloth occasionally to
keep the product looking new. Do not use harsh chemicals, cleaning solvents
or strong detergents to clean the clock.
Dimensions
Size: 70mm x 70mm x 70mm (approx. 2.8 × 2.8 × 2.8 inches)
Weight: 264g (approx. 9.25 ounces).
Terms and Conditions of Sale
All goods are guaranteed against faults for 12 months from date of invoice.
Faults should be notified to RNIB prior to return, who will issue a returns
authorisation number (RMA).
Goods can be returned as “unsuitable” within 30 days of delivery, as follows:-
1. Customer must contact RNIB Customer Services to obtain a returns
authorisation number (RMA).
2. Items must be returned in original packaging and condition.
3. Goods must be marked “Returns” and must show the authorisation
number.
4. Goods lost in transit will only be refunded on proof of postage.

7
5. Goods marked as “non returnable” in the RNIB catalogues cannot be
returned for hygiene reasons - unless faulty, and software products whose
seal has been broken cannot be returned unless faulty.
Where goods are sold to organisations, who then sell on the goods, the
guarantee will commence from the date of original purchase from RNIB.
None of the above terms and conditions affect your statutory rights. If you
require further information or clarification of these terms and conditions please
contact: -
RNIB
PO Box 173
Peterborough PE2 6WS
U.K.
Telephone: [phone]
Textphone: 0845 758 5691
Email: [email protected]rg.uk
RNIB website: rnib.org.uk
Registered charity No. 226227
Overseas customers should contact RNIB Export Department at the above
address or call:
Telephone: [phone]
Export direct fax: [phone]
Email: [e-mail]
Product Regulations
This product is CE marked.
The materials, components, and assemblies in this product comply with 'The
Restriction of the Use of Certain Hazardous Substances in Electrical and
Electronic Equipment Regulations 2006' (RoHS).
Customers are advised to return this product, free of charge, to their supplier
or the manufacturer at the end of its life. This is to comply with 'The Waste
Electrical and Electronic Equipment Directive' (WEEE).

8
Keep up-to-date with new products from RNIB
New Product Guide is a free bi-monthly publication packed with information on
accessible products from RNIB relevant to your everyday life. It also features
details of any special offers or discounts, information about popular products
and other news and events that may be of interest. Available bi-monthly in
braille, audio, by email, on disk and online.
To subscribe contact RNIB on 0303 123 9999, alternatively visit our Online
shop at rnib.org.uk/shop
Revised September 2009.