Roland V-Mixer M-400 Instruction and safety manual

Functionality added to the M-400 Ver.1.100
• Support for RS-232C transmission and reception
• M-400RCS support
Now you can use the RS-232C connector located on the rear panel to control the M-400 from an external
computer or other device. For details on the RS-232C commands, refer to the “M-400RS-232C Reference” (PDF
version), which you can obtain from the Roland website listed below.
http://www.rolandsystemsgroup.net/
1
An “RS-232C tab” has been added to the REMOTE popup of the SYSTEM screen.
fig.ScrRS232CGuide.eps
1. MIDI/RS-232C selection indication
This shows the status of the rear panel MIDI/RS-232C select switch.
2. RS-232C rate setting buttons
These buttons specify the RS-232C communication speed. Choose the setting that matches the speed setting
on your computer. Make sure to switch OFF the M-400’s power before operating the MIDI/RS-232C select
switch.
The M-400 can now be remotely controlled from M-400RCS via its rear panel USB connector.
M-400RCS is application software that runs on Microsoft(R) Windows(R) XP. It allows you to edit M-400
project files and to remotely control the M-400.
You can obtain the “M-400RCS” software and the “M-400RCS Users Guide” (PDF version) from the Roland
website listed below. For details on using M-400RCS, refer to the “M-400RCS Users Guide.”
http://www.rolandsystemsgroup.net/
Copyright © 2007 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Functionality added in version 1.100
RS-232C support
RS-232C tab
M-400RCS support
12
M-400 40784456 1N
*40784456-01*
M-400_l_ver1100_e1.fm 1 ページ ２００７年１２月１７日 月曜日 午後５時９分