Rona EL1229D User manual

Modèle/Model : 20095220
EL1229D
Nom du produit
Wall Mount Electric Fireplace
Product name
Foyer electrique Mural
Service à la clientèle / Customer Service : 1-866-206-0888
Notre personnel du service à la clientèle est disponible pour vous aider. Pour obtenir de l’aide pour le montage de votre
produit, pour signaler des pièces endommagées ou manquantes, ou pour toute autre information à proposde ce produit,
veuillez composer notre numéro sans frais.
CONSERVEZ CE GUIDE
Conservez ce guide avec la facture d'origine dans un endroit sûr et sec pour référence future.
Our Customer service staff is available to help you. For help with product assembly, to report damaged or missing parts, or
for any other information about this product, please call our toll-free number.
SAVE THIS MANUAL
Keep this manual and the original sales invoice in a safe, dry place for future reference.

SAVE THIS MANUAL
SAVE THIS MANUALSAVE THIS MANUAL
SAVE THIS MANUAL
You will need this manual for safety instructions, o eration rocedures, and warranty.
You will need this manual for safety instructions, o eration rocedures, and warranty.You will need this manual for safety instructions, o eration rocedures, and warranty.
You will need this manual for safety instructions, o eration rocedures, and warranty.
Put it and the original invoice in a safe, dry lace for future reference.
Put it and the original invoice in a safe, dry lace for future reference.Put it and the original invoice in a safe, dry lace for future reference.
Put it and the original invoice in a safe, dry lace for future reference.
Table of Contents
Table of ContentsTable of Contents
Table of Contents
QUICK REFERENCE GUIDE…………………………………Page 2
IMPORTANT SAFETY INSTRUCTIONS…………………… Page 3
INSTALLATION INSTRUCTIONS…………………… …… Page 4
OPERATE INSTRUCTIONS …………………………………Page 5
MAINTENANCE………………………………………… ……Page 7
TROUBLE SHOOTING… ……………………………………Page 7
WARRANTY……………………………………………………Page 7
Quick Reference Guide
Quick Reference GuideQuick Reference Guide
Quick Reference Guide
Read All Instructions Before Using This Appliance
Read All Instructions Before Using This ApplianceRead All Instructions Before Using This Appliance
Read All Instructions Before Using This Appliance
1.Before permanently plug it into outlet to verify that the circuit breakers for the outlet are on.
2.The heater may emit a slight,harmless odor when first used.This odor is normal and is caused by
the initial heating of internal heater parts and will not occur again.
3.If your does not emit heat,consult the Trouble Shooting” section of this manual.
Keep drapery and other furni
Keep drapery and other furniKeep drapery and other furni
Keep drapery and other furnishings at least 3.0feet/0.9 me
shings at least 3.0feet/0.9 meshings at least 3.0feet/0.9 me
shings at least 3.0feet/0.9 meter
terter
ter from the front and sides of the appliance.
from the front and sides of the appliance.from the front and sides of the appliance.
from the front and sides of the appliance.
UNPACKING AND INSTALLING THE ELECTRIC FIREPLACE
UNPACKING AND INSTALLING THE ELECTRIC FIREPLACEUNPACKING AND INSTALLING THE ELECTRIC FIREPLACE
UNPACKING AND INSTALLING THE ELECTRIC FIREPLACE
1.Open the carefully and remove the heater
2.Remove and discard the plastic bag
3.Recycle packing materials where available.
WARNING : KEEP PLASTIC WRAPPING AWAY FROM CHILDREN
WARNING : KEEP PLASTIC WRAPPING AWAY FROM CHILDRENWARNING : KEEP PLASTIC WRAPPING AWAY FROM CHILDREN
WARNING : KEEP PLASTIC WRAPPING AWAY FROM CHILDREN
1.Keep the original packing for future and/or storage.
2.Keep the front of the unit trough which the heat is radiated,at least 3 ft(0.9m)awa from furniture,curtains and
other flammable objects/material at all times.
3.The power cord must remain at the back of the appliance and must not be in contact with an hot element.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER
-
SERVICEABLE PARTS INSIDE
1.Risk of fire : keep combustible away from the front of the appliance.
2.Servicin
g should be done only while the electrical heater is disconnected from the power supply.

IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions
should alwa s be followed to reduce the risk of fire,
electric shock, and injur to persons, including the
following:
1.Read the manufactuers instructions before using this
appliance.
2.This appliance is hot when in use. To avoid burns, do
not let bare skin touch hot surface. The grill at the top
of this fireplace will become hot when the appliance is
turned on. Keepflammable materials, such as
furniture, pillows, bedding, papers, cloth, curtains, etc.
at least 3’ (0.9m) awa from the front of the appliance.
Keep all items awa from the sides and back of the
appliance and take special care not to block the air
intake or exhaust vents.
3.Extreme caution is necessar when the appliance is
used b or near children or invalids and whenever the
appliance is left operating and unattended.
4.Do not operate the appliance if the power cord or plug
has been damaged or the appliance has been
damaged or malfunctioned in an wa . Take the
appliance to an authorized service facilit for
examination, electrical or mechanical adjustment or
repair.
5.Do not use outdoors.
6.Do not use the appliance in bathrooms, laundr rooms
or other similar indoor locations where it ma contact
water. Never locate the appliance where it ma fall
into a bathtub or other water container.
7.Do not run the power cord under carpeting. Do not
cover the power cord with throw rugs, runners, or
similar floor coverings. Take care to position the cord
awa from high traffic areas such that it cannot be
tripped over.
8.To disconnect the appliance, turn all controls to “OFF”,
then remove the plug from the electrical outlet.
Alwa s unplug the appliance when not in use.
9.This appliance has a polarized plug(one blade is
wider than the other).This plug will fit in a outlet onl
one wa . If the plug does not fit full in the outlet,
reverse the plug. If it still does not fit, ontact a
qualified electrician to install the proper outlet. Do
not change the plug in any way.
10.Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause
an electric shock or fire, or damage the appliance.
11.To prevent a possible fire, do not block air intake or
exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become
blocked.
1 .All electrical heaters have hot and arcing or
sparking parts inside. Do not use in areas where
gasoline, paint, or flammable liquids are used or
stored or where the appliance will be exposed to
flammable vapours.
13. Avoid using this appliance with an extension cord.
Extension cords may overheat and cause a risk of
WARNING:
WARNING: WARNING:
WARNING:
Any use of this appliance other than that recommended by the manufacturer in this
owners manual may cause fire, burns, electric shock and/or other serious
injuries or death
.

fire. Always plug heaters directly into a wall
outlet/receptacle.
14. Use the heater only as described in this manual.
Any other use not recommended by the
manufacturer may cause fire, electrical shock, or
injury to persons.
15. Do not attempt burn wood or other materials in this
electric fireplace.
16. This appliance comes equipped with an overheat
protection safety device. Should the appliance
begin to overheat for any reason, it will
automatically turn all heater functions of the
appliance off. The appliance will have to be reset
prior to continuing use. To reset the overheat
protection safety device, turn all controls off and
unplug the appliance, wait 10 minutes, plug the
appliance back and turn on.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
INSTALLATION
INSTALLATION INSTALLATION
INSTALLATION I
II
INSTRUCTIONS
NSTRUCTIONSNSTRUCTIONS
NSTRUCTIONS
#1 wall bracket 1PCS
#2 bracket 1PCS
#3 plastic anchors 7PCS
#4 screws ST4.2*40 7PCS
#5 screws ST3.5*8 2PCS
# pebbles 1bag
Tools required : Philips Screwdriver(Not Included)
Step 1: Drill 7 holes onto the wall: 5 holes evenl spaced, 1035 mm from ground and 2 holes evenl spaced, 584
mm from the ground as shown in Figure 1 . Then insert 5 plastic anchors (#3) onto the predrilled holes, finall use
the 5 screws(#4) to fix the wall bracket (#1) onto the wall as shown in Figure 2.

Step 2: Remove the front glass,then use 2 screws (#5 ) to fix the bracket(#2) at the bottom of insert as shown in
Figure 3 .Then hang the insert onto the wall bracket (#1) and use 2 screws (#4) to fasten the bracket(#2) on the
wall as shown in Figure 4 .
Step 3: Place the pebbles(#6) on the front of PP plastic board as shown in Figure 5 .Then assemble the front glass
b locking the left hanging plate(#7) and right hanging plate(#8) as shown in Figure 6. Then remove the protective
covering on glass surface.
Note:left hanging plate and right hanging plate have been installed on the front glass before shipment.