Rosen F150 w/Ford SYNC User manual

Honda Accord Quick Start Guide
Toyota Venza Quick Start Guide
Multimedia Navigation System
• Navigation
• Back-up camera Included
• Play Audio CDs and MP3 Discs
• Supports steering wheel controls
• Back-up camera included
System Features:
F150 w/Ford SYNC Quick Start Guide
*FOR MODELS WITH FORD SYNC® ONLY

NOTICE OF INTENDED USE
Some features of Rosen Entertainment Systems are not intended for viewing by the driver when the vehicle is in motion,
such as movie playback. When using navigation, minimize the amount of time spent viewing the screen and use voice
prompts as much as possible. Avoid prolonged use of the touch screen controls. Such use might distract the driver or
interfere with the driver’s safe operation of the vehicle, and thus result in serious injury or death. Such use might also
violate state or local laws.
Rosen Entertainment Systems disclaims any liability for
any bodily injury or property damage that might result
from any improper or unintended use.
About the Registered Marks
This item incorporates copy protection technology that is protected by U.S. patents and other
intellectual property rights of Rovi Corporation. Reverse engineering and disassembly are
prohibited.
Ford SYNC® is a registered trademark of Ford Motor Company.
NAVIGATION MAPS
Car navigation maps are frequently updated. While the database was judged to be as ac-
curate as possible at the time of its release, a map database can never be 100% accurate.
Road information that is maintained in the map databases, such as turn restrictions or road
names may change over time.
Errors or missing information in the map data are not covered by the Product Warranty. New
and/or updates for the map data are the responsibility of the End-user.
NOTE: Features and specications listed in this manual are subject to change without notice.
1
Copyright © 2009 by Rosen Entertainment Systems. All rights reserved. Except as permitted
under the Copyright Act of 1976, no part of this publication may be reproduced or distributed in
any form or by any means, or stored in a database or retrieval system, without the prior written
permission of Rosen Entertainment Systems.
Notices

2
Turning The System On/Off
Vehicle ignition must be On or in ACC Mode to
operate system.
Press the DISP button on the panel to dim
backlight of the display or turn display off.
Your system will automatically default to the last screen you were on prior to turning off the unit.
The Information Bar is located at the
top of the screen. Depending on the
source, it will provide information or content
sensitive controls
This will take you to the Settings
Menu for advanced control settings.
The Source Tabs located at the bottom of
the screen will give you direct access to
common sources.
When the vehicle is turned off, the unit will
automatically turn off.
Basic Functions
Screen Organization
NOTE:Most functions on the Rosen unit are controlled by either SYNC or
the Factory buttons. Please refer to your Factory Owner’s Manual for all
other instructions.

3
Touch to switch between the pages
that list the 10 presets assigned though the
F150 vehicle buttons
To set a Preset, you will need to do so using
the 1-10 Factory Preset buttons.
Touch to switch between the pages
that list the 10 presets assigned though the
F150 vehicle buttons
Functions
Touch Button Descriptions
Satellite Radio (If Equipped)
Most functions on the Rosen unit are controlled by either SYNC or the Factory buttons.
Please refer to your Factory Owner’s Manual for all other instructions.
CD
When you insert a CD in the Rosen unit and
access the CD screen, you will be able to
see the Track number and time played.
You will not be able to control the CD
functions on the Rosen unit. To select the
Previous and Next track, you will need to
use the Factory vehicle buttons.

4
Most functions on the Rosen unit are controlled by either SYNC or the Factory buttons.
Please refer to your Factory Owner’s Manual for all other instructions. Bluetooth
Your phone will need to be paired by using
SYNC. Please refer to the Factory SYNC
manual for instructions.
On the Rosen unit, you will be able to dial
phone numbers and receive calls. All other
Bluetooth functions will be accessed through
the Factory Bluetooth.
Short Press to answer call, long press
to end call
Change the brightness, color and contrast for
Navigation and AUX In displays.
Press to increase the value
Press to decrease the value
Press to reset back to original display
settings
Display Settings
The time displayed on all screens
Turn backup camera or sensors On/Off
Allows voice prompt to interrupt main au-
dio when directions are being given, while
you are not in the navigation screen.
Button beep On/Off
System Settings
Note: “PHONE” is highlighted BLUE when a phone is paired to Rosen Bluetooth

6
5
Understanding the Map
Select the Quick
Menu to access the
most used functions
These displays show
you the distance, time
left and the estimated
arrival time of your trip
The top part of the screen shows
you what the next street is and which
direction to turn on your route
Shows you the street
you are currently on
Access the Navigation Menu
Find an address or Point of Interest and
access the Favorites and History menu
Displays the route details and allows
you to edit, change or cancel existing
route
Displays current position, surrounding
map area and route.
Customize the navigation software
Navigation

6
Modifying Existing Routes
You can modify an existing route by accessing either the Quick Menu or Main Navigation
menu
Quick Menu
Located in the top right corner of the
map screen is the Quick Menu. In
this screen, there is a selection of
functions that are frequently needed
during navigation.
You can use this option to search for
places of interest along the way of
your route, such as: Gas Stations,
Restaurants, Parking, etc.
You can use this option to se-
lect an alternative route to your
destination.
This option is a good way to
change road types and modes.
You can avoid highways, allow
toll roads, etc.

Enter or Find Address
If you are on the Map screen, press MENU. In the Navigation Menu, select Find Address.
Note: By default, the software proposes the country and state where you are currently
located.
1. Touch “City Name” and the key-
board screen will appear.
2. Your current city will automatically
default. To search for a different city,
start typing each letter of the City
name
Tap to conrm city
3. A “Select City” screen will appear.
This will show a list of cities that
match your selection. Touch the city
you desire.
4. Select “Street” and the keyboard
screen will appear.
7

8
7. Repeat these steps for House number,
or if you do not know it, you can select the
SELECT STREET option.
8. A map will appear.
Click Next and a short
summary of the route will ash on the
screen for a few seconds.
9. After the summary, the map ap-
pears showing the entire route.
Tap to start your journey.
5. Start typing each letter of the street
name.
6. A Street Name list will appear. Se-
lect the one you are looking for.

Safety Information and Precautions
WARNING! Please read and follow the following safety precautions.
Failure to follow the instructions below may increase
your risk of collision and personal injury.
The Rosen Navigation software is not a substitute for your personal judgment. The route suggestions should never supersede
any local trafc regulation or your personal judgment and /or knowledge of safe driving practices. Prior to completing any ma-
neuvers suggested by your Rosen Navigation software (for example, a U-turn or a left turn), verify that you can legally and safely
complete the maneuver. Do not follow route suggestions if they direct you to perform an unsafe or illegal maneuver, would place
you in an unsafe situation, or would route you into an area that you consider unsafe.
Do not use the Rosen Navigation software to locate emergency services (such as police, re stations, hospitals, and clinics).
The database may not include all emergency service providers. Use your own best judgment and ask for directions in these
situations.
If the vehicle is in motion, only a passenger should program the Rosen Navigation software. The driver should not program the
system unless the vehicle is parked in a safe location.
The Rosen Navigation software’s map database provides information on suggested routes without regard to factors that may
affect your driving experience or the time required to arrive at your destination. For example, the system does not reect road de-
tours, closures or construction, some road characteristics (e.g., road surface, slope or grade, weight or height restrictions, etc.),
temporary trafc congestion, weather conditions, and similar factors.
Vehicle Position
The Rosen Navigation software’s computer considers vehicle speed and heading changes, together with longitude and latitude
information, to accurately determine vehicle heading and position on a digital map.
Map and Information Database
The map database used by your Rosen Navigation software was created using high-resolution aerial and land based data col-
lection.
Car navigation maps are frequently updated. While the database was judged to be as accurate as possible at the time of its
release, a map database can never be 100% accurate. Road information that is maintained in the map databases, such as turn
restrictions or road names may change over time.
Errors or missing information in the map data are not covered by the Product Warranty. New and/or updates for the map data
are the responsibility of the End-user.
End-User License Agreement
Please refer to the Rosen Navigation User’s Manual to review and accept the terms and conditions in the End-User License
before operating this product.
All rights reserved. Copyright 2011. DP-FD1031 Rev A
Rosen Navigation Information