Roswell 6510 User manual

6510 In-Boat Speaker Pkg
Assembly Instructions
B
A
C
Pg. 1/2
6510 SPEAKER PKG HARDWARE
D
Rev. 03-Aug-11
TOOLS REQUIRED
• For safety, turn off the audio system and battery switch prior to beginning installation. If your vessel does not have a battery
switch simply disconnect the negative lead from the battery terminal.
• Use extreme caution before cutting and drilling holes to avoid damaging fuel lines, hydraulic lines, or existing electrical
components.
• If additional wiring is required, we recommend using 16 gauge wiring and running all wires prior to mounting the speaker in
place. Leave some slack in the wire to allow for easier installation and to prevent tension on the wire.
• Avoid running wires near sharp edged surfaces. Never run wires exposed on the deck, protecting the wires behind cover
offers the best protection from marine elements.
• All wiring for these speakers should be done by a qualified marine technician.
PREPARATION
C
x2 D x2
A
x4 B x4
Locate a suitable area to mount the speaker in your vessel. Ensure
the area is large enough to evenly mount the speaker and grill.
Ensure the area behind the mounting area is spacious enough to
allow proper fit and air flow.
First use a drill and 1/4” bit to start the hole, then cut the 5.59”
diameter mounting hole with a jig saw.
Use the speaker as a template to mark the locations of the
mounting screws. Make sure the speaker is in the desired
orientation before marking the screw hole locations. Mark the
holes with a pencil then drill the holes with a 1/8” bit.
Use the 5.59” inner circle of the plastic ring as a cutout template
to mark the area for the speaker.
2” clearance all around
1)
2)
Mounting screw holes make X pattern
Pencil
Safety GlassesDust Mask
Jig Saw
1/8” & 1/4” Bits
Power Drill
Phillips Screwdriver
Wire Stippers & Crimps
5.59” cutout template

Rev. 03-Aug-11 Pg. 2/2
If you have any questions please call : 1-855-962-WAKE(9253)
EF
H
www.roswellwakeair.com
Observing speaker polarity, route speaker wires and connect to
the male speaker terminals matching the same size female quick
connectors.
Strip 1/4” off of the positive wire and insert into the larger quick
connect and crimp. Strip 1/4” off of the negative wire and insert
into the smaller quick connect and crimp.
Install speaker and plastic ring into mounting hole and fasten
with supplied hardware by hand using a Phillips screwdriver.Test
for proper operation.
GOnce Speaker is mounted and operational, fasten the stainless
steel grill with supplied hardware.
A
x4 B x4
C
x2
D
x2
+ve −ve