Roswell WAKE-AIR User manual

S.I. Team Rack
Assembly Instructions
A B
D
C
E
TOOLS REQUIRED
Pg. 1/2
3/16" Allen Key
A
x4 B
x4
B
x4
C
x2 D
x2
S.I. TEAM RACK HARDWARE
5/32" Allen Key
A
x4
***BOARD RACK BUNGEE CORD AND CLIP NOT ILLUSTRATED FOR IMAGE CLARITY***
***UNIVERSAL CLAMP SOLD SEPARATELY***
THREADLOCKER
3/32" Allen Key
3/16"
F
C
x2
Alternate View
Apply RED Loctite to both (C) locking pins and insert into the
back of the medallion.
Apply RED Loctite to 4 (B) bolts and sssemble the backing
plate to the universal clamp.
Right Tine
Left Tine
Rev. 24-Feb-11
PARTS
TINES
x2
MEDALLION
x1
BACKING
PLATE
x1
RED
THREADLOCKER
Test fit the clamp to your tower and rotate the rotational disc
so that the rack will be as close to horizontal as possible
when assembled.
Horizontal
Depending on the tubing
diameter of your tower, place
the proper size plastic insert
into the clamp, 1.9’’ or 2.375’’.
(1.6”,2.0” and 2.5” are
available upon request).
Tighten the clamp around
the tubing. Apply RED
Loctite to the clamp bolts
and fasten the clamp into
position on the tube. Apply
RED Loctite to the clamp
set screw and tighten.
3/16"
THREADLOCKER
5/32"
THREADLOCKER
3/32"
THREADLOCKER
Apply RED Loctite to 4
(A) bolts and assemble
the tines to the backing
plate.

CAUTION
When attaching or removing the board rack strap be sure you have a good grip on the clip. Clip
and strap may be under tension and could cause injury.
Always remove all equipment from rack when boat is being transported on a trailer.
Rev. 24-Feb-11 Pg. 2/2
If you have any questions please call : 1-780-962-0868
GPosition Medallion on backing plate using the locking pins as
guides. H
D
x2
Apply RED Loctite to both (D) set screws, hold the
medallion in place and insert the 2 set screws through
the bottom of the backing plate.
TOP VIEW
3/32"
THREADLOCKER
www.roswellwakeair.com