Rottefella 30400271 Installation instructions
1
Align the binding heel hole with
the drilled one in the roller ski.
Use the screws included with the
binding and screw the heel into
place. Tighten by hand.
Push the flex inntil it clicks in place
after screwing in all four screws.
Step into the binding. Close the
lever til you hear a click.
Turn the handle on the safety lock,
covering the red line. The safety
lock is now in a locked position.
Place the binding house on the
binding heel aligning the binding
house holes with the drilled ones
in the roller ski. Use the screws
included and screw the house
into place. Tighten by hand.
Place the Roller ski inserts into
the Rottefella jig. Adjust the in-
sert to the correct shoe size and
clamp the jig onto the roller ski
as far back as possible.
Use the recommended drill bit
size for correct diameter.
Mounting the
Roller ski jig
Mounting of binding
house and heel
Art nr: 30400271
HOW TO MOUNT ROTTEFELLA ROLLERSKI
Drill bit (screw length = 16.3 mm): 3.6x9 mm
Drill bit (screw length = 21.8 mm): 3.6x15.5 mm
Warning: For Roller ski: Use Rottefella Rollerski binding with the included screws. Only suitable for roller ski purpose. Tighten screws regularly for safety. Use the safty lock for safe skiing.
For longer lasting bindings, keep them free of dirt and mud. A damaged or cracked roller ski binding should never be used.
2Mounting the flex
Locked position
Unlocked position
3
Using the safety
lock
4
Scan the QR-code and
see how Rottefella
Rollerski Saftey Lock
works.
