5.1 Getting started:
1. Ta e the appliance along with the other components of the DERMA PERFECT out of its
box.
2. Chec that the disposable Lamp is correctly inserted at the end of the appliance.
3. Plug the Adaptor power cord into the DERMA PERFECT appliance’s soc et (no.18 p. 9).
4. Plug in the Adaptor to a mains soc et: the ”stand-by” mode indicator LED comes on: your
DERMA PERFECT appliance is now ready for use.
Your s in must be shaven, clean, dry and free of any powder or deodorant residue.
5. Press the Start button. The Power Light will come on and you will hear a normal ventilation
sound.
6. About 3.5 seconds after you press the Start button, the indicator LEDs will come on and
stay on. The appliance starts off automatically on minimum power.
The appliance is now ready to emit its first pulse.
7. If you want to increase or reduce the power, press either the “+” or “- “ on the power
selector until you reach the power level you require (see
details on power level in chapter 5.2 page 12).
8. Press the appliance window up against the area of s in to be treated so as to achieve
optimal contact.
The S in Contact Detector will then chec that the appliance window is in complete contact
with the s in. The indicator LEDs will then start flashing to indicate that the appliance is
ready to emit the pulsed light.
9. Press on the trigger.
The system ill also check the colour of the skin before activating the pulsed light. If
the skin colour is sufficiently fair for a safe application, the appliance ill then emit a
pulse on to the skin and the Indicator LEDs ill go out.
You ill see a light flash and, simultaneously, you ill hear a slight ‘beep’ at each pulse,
hich is normal. It is possible that you may feel a slightly hot and tingling sensation.
Your DERMA PERFECT appliance ill recharge immediately bet een each pulse. After
3.5 seconds, the Indicator LEDs ill come on again.
If you don’t see any light pulse and the indicator LEDs start flashing green and orange,
this means that the colour of your skin, measured by the Skin Colour Detector, is too
dark for a safe application. If you ant to use the appliance again, but on a lighter area,
you must s itch it off and then s itch it back on again, other ise it ill remain locked
in safety mode (flashing green and orange).
V- I STRUCTIO S FOR USE