Rowlinson Sorrento set User manual

Sorrento set assembly
Assembly Instructions
English SS264A
No. Components Qty.
1Leftarm 3
2 Right arm 3
3 Sofa seat 1
4 Sofa back 1
5 Armchair back 2
6 Armchair seat 2
7Tableleg 4
8Tabletop 1
9 Table shelf 1
10 Table glass 1
11 Cushions 4
Before assembly
•We recommend that time is taken to
read the instructions before starting
assembly, then follow the easy step by
step guide. The instruction sheet is only
a guide to the assembly.
Certain items may not be shown
to scale.
•Check all components prior to assembly
•We recommend this product should be
assembled by no less than two people
No. Fixing kit Qty.
12 30mm bolts 31
13 15mm bolts 12
14 Plastic caps 43
15 Allen key 1
Recommended tools for assembly
•Allen Key (supplied with kit)
2010 © Rowlinson Garden Products Ltd
If in doubt of any aspect regarding the assembly, use or safety of your furniture set please contact us :
Help Line (Normal Office Hours) 01829 261 121
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle Nr. Nantwich
Cheshire
CW5 6BN
We constantly improve the quality of our products, occasionally the
components may differ from the components shown and are only
correct at time of printing. We reserve the right to change the
specification of our products without prior notice.
x 2
1 2
34
5
6
3. Coffee Table
Place the table top upside down and attach a leg to each corner using 1 x 15mm bolt per leg.
Position the shelf between the four legs and attach to the legs using 2 x 15mm bolts per leg.
Put a plastic cap on the head of each bolt and then turn the table over the right way and place the glass in
the centre of the table top.
7
9
8
10

1. Sofa
Attach the seat to the seat back using 3 x 30mm bolts
Push a 30mm bolt through each of the two holes in the back of the arm, screw each bolt into the
corresponding holes in the back rest. To attach the front of the arm, push a 30mm bolt through each of
the two holes on the underside of the seat and screw them into the corresponding holes in the front of
the arm.
attach the front of the
arm underneath the seat
Attach the other arm in the same way. Put a plastic cap on the head of each bolt and place two cushions
on the seat to finish.
2. Armchairs
Attach a seat to a seat back using 2 x 30mm bolts
attach the front of the
arm underneath the seat
Push a 30mm bolt through each of the two holes in the back of the arm, screw each bolt into the
corresponding holes in the back rest. To attach the front of the arm, push a 30mm bolt through each of
the two holes on the underside of the seat and screw them into the corresponding holes in the front of
the arm.
Attach the other arm in the same way. Put a plastic cap on the head of each bolt. Assemble a second
armchair in the same way and place a cushion on each chair to finish.