RS PRO 146-4645 User manual

AHD Bullet Camera (1080P)
Disposal of your old appliance
This lightning flash with arrowhead symbol within an equila-
teral triangle is intended to alert the user to the presence or
uninsulated dangerous voltage within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle is inten-
ded to alter the user to the presence of important operating
and maintenance(servicing) instruction in the literature acco-
mpanying the product.
FCC WARNING: This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment may cause harm-
ful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
This equipment has been tested and found to comply with the limits
for a class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate ratio frequency ener-
gy and, if not installed and used in accordance with the instruction ma-
nual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.
* Caution: Danger of explosion if battery is incorrectly replaced. Re-
placed only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufac-
turer’s instructions.
* Holes in metal, through which insulated wires pass, shall have smoo-
th well rounded surfaces or shall be provide with brushings.
WARNING : Do not install this equipment in a confined space such
as a bookcase or similar unit.
WARNING: Wiring method shall be accordance with the National
Electric Code, ANSI/NFPA 70
CAUTION : TO REDUDE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK) NO USER-SERVICE-
ABLE PARTS INSIDE REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING : This is a class A product in a domestic environment this
produce may cause radio interference in which case the user may be
reuqired to take adequate measures.
WARNING : To reduce a risk of fire or electric shock, do not expose
this product to rain or moisture.
Caution : This installation should be made by a qualified service per-
son and should conform to all local codes.
Caution : To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
Caution : The apparatus should not be exposed to water (dripping or
splashing) and no objects filled with liquids, such as vases, should
be placed on the apparatus.
1. When this crossed-out wheeled bin symbol is attached to
a product it means the product is covered by the Euro-
pean Directive 2002/96/EC.
2. All electrical and electronic products should be disposed
of separately from the municipal waste stream via desig-
nated collection facilities appointed by the government or
the local authorities.
3. The correct disposal of your old appliance will help pre-
vent potential negative consequences for the environ-
ment and human health.
4. For more detailed information about disposal of your old
appliance, please contact your city office, waste disposal
service or the shop where you purchased the product.
This product is in compliance with the essential require-
ments and other relevant provisions of Directive 2004/
108/EC and 2011/65/EU.
To disconnect power from the mains, pull out the mains cord plug.
When install the product, ensu7re that the plug is easily accessible.
Important Safety Insructions
1. Read these instructions. - All these safely and operating instruc-
tions should be read before the product is operated.
2. Keep these instructions. - The safety, operating and use instruc-
tions should be retained for future reference.
3. Heed all warnings. - All warnings on the product and in the ope-
rating instructions should be adhered to.
4. Follow all instructions. - All operating and use instructions should
be followed.
5. Do not use this apparatus near water. - For example: near a bath
tub, wash bowl, kitchen sink, laundry tub, in a wet basement; near
a swimming pool; etc.
6. Clean only with dry cloth. - Unplug this product from the wall outlet
before cleaning. Do not use liquid cleaners.
7. Do not block any ventilation openings, Install in accordance with
the manufacturer’s instructions. - Slots and openings in the cabi-
net are provided for ventilation, to ensure reliable operation of the
product, and to protect it from overheating. The openings should
never be blocked by placing the product on a bed, sofa, rug or other
similar surface. This product should not be placed in a built-in in-
stallation such a bookcase or rack unless proper ventilation is pro-
vided and the manufacturer’s instructions have been adhere to.
8. Do not install near any heat sources such as radiators, heat regi-
sters, stoves, or other apparatus(including amplifiers) that pro-
duce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If
the provided plug does not fit into you outlet, consult and electri-
cian for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particu-
larly at plugs, at the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tipping over.
13. Unplug this apparatus during lightning storms or when unused for
long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way (such
as power supply cord or plug damage), liquid has been spilled
or object have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally or has
been dropped.
Instruction Manual
AHD Bullet Camera (1080P)
146-4645
EN

CAUTION
• Do not open or strike this equipment. Sensitive electronics inside are vulnerable to excessive shock.
• Do not install the equipmentnear anynaked flames or heat sources. Excessive heat could damage this unit.
• Do not cover cloth or to install this unit in a poorly ventilated place. This may lead to overheating.
• Do not continue to operate if there appears to be fault.
If the unit ceases tofunction, contact qualified service personnel for help.
•Do not touch the power connection with wet hands as this increases the risk of short circuit or electric shock.
• Do not damage the power cord as this increases the risk of fire or short circuit.
AHD Bullet Camera (1080P) AHD Bullet Camera (1080P)
with a
Installing the camera
Trouble Shooting
If you are not able to view anything on your screen :
* Check the power, video, strength of signal, and monitor in-
put / output.
* Check the camera connection without monitor.
FOR FUZZY SCREEN
* Check camera lens for dust or dirt. If present wipe away
with dry cloth or fine brush.
* Check the camera does not have direct exposure to sunlight.
* Ensure the camera protection film is removed before use.
FOR DARK SCREEN
* Check your monitor brightness.
* Adjust the camera position or angle of lens. If the problem
remains please contact technical support.
1. Locate installation area ensuring that it can
support the camera’s weight indefinitely.
2. Please ensure the front of the camera is facing
toward the surveillance area. The bracket has
axis of adjustment, and can be secured to a
wall or base by secure screws.
3. The lens is a fixed focus, and cannot be
adjusted.
4. Connect power jack(DC jack) to 12Vdc and
Video jack(BNC jack) to monitor or to DVR.
5. Under low illumination, the colour changes to
black and white. This also helps the clarity of
the image at night.
FEATURE
AHD(1080P)_1100TVL
VIDEO Output : AHD
Min. Ill. : 0.08Lux / Color, 0.008 Lux / BW
3D-DNR, SENS-UP (X6)
Mega 3.6mm Fixed Lens
Power Source : DC12V (
±30%)
Weatherproof type
SPECIFICATION
Image Device
Total Pixels
Effective Pixels
Sync System
Video Output
S/N Ratio
LENS
White Balance
M inimum Illumination
Shutter Speed
Sens-up
Day & Night
DNR
Power Consumption
Operation Temperature
Storage Temperature
Weight
Housing
Dimension(mm)
IP
M ore Than 52dB (AGC Off)
Lens M ega f=3.6mm Fixed lens
ATW
19.5
Φ
× 72.5 M M
DC12V ( ±30% ), 100mA
-10℃~＋50℃
-20
℃
~
＋
60
℃
Approx 85gincluded bracket
ALUM INUM
IP 66, Weather-proof
3D-DNR
AUTO
AUTO(X6)
AUTO
1080P AHD
Horizontal Resolution
Progressive
AHD
Electronic Shutter
PAL : 1/30~1/50,000sec (Auto)
NTSC : 1/30~1/50,000sec (Auto)
Please connect AHD camera with
“1080p AHD DVR” or “Hybrid DVR”
to be available 1080p AHD image.
1/2.9 inch, 2.12 Megapixel Sony Exmor CMOS
2001(H) x 1121(V)
1936(H) x 1097(V)
COLOR : 0.08Lux / BW : 0.008Lux
1/2.9" 2.12 MP Sony CMOS Sensor
How to use AHD Bullet camera
Before installing or adjusting please read the installation
guide that accompanies this product. Failure to follow
warning notices and instructions may result in property
damage. Improper installation and/or operation will void
the warranty.
Before using or Installing.
Please do not make any attempt to disassemble this
this camera.
To avoid any electrical shock, please do not remove the
camera cover and screw.
Use a dry towel to wipe the camera and a weak cleaning
detergent to remove any stains.
please operate the camera within the temperature
range -10ºC and 50ºC.
Please do not operate the camera if there is a lot of
smoke or gas, and under direct sunlight.
Do not aim the camera directly at bright objects.
Please handle the camera with care, and try not to hit
or shake.
Children should not handle or operate the camera.
Use of 12Vdc. (Please use adapter 500mA for 12Vdc)
Do not use the camera in a humid or wet area.
Do not install the camera where there is a lot of vibration.
Do not attempt to open the after installation
and image adjustment.
①
②
③
④
①Weatherproof cap
②Bracket
③Video jack
④Power jack
AHD DVR
Adaptor
Power jack
Video jack
MONITOR