Ruark Audio R7 AV Mount User manual

R7 AV Mount assembly instructions
1 Secure TV brackets to rear of TV
Do not use this prouct with a television larger than
50” or heavier than 25kg.
You will need a suitable Pozidrive screwdriver.
Place your TV face down on a stable cloth-covered
surface ensuring all cables are disconnected.
Determine the size of screw required for your TV. Secure
the TV brackets to the back of your TV using correct
screws and spacers as shown.
Make sure the TV brackets are vertically centred and
level with each other, and that the four screws are
correctly tightened.
If the supplied screws do not t your TV, contact your
Ruark Audio dealer.
Warning
If this product is not used correctly it may result in
damage or serious injury.
If you do not understand these instructions, or have any
doubts about your ability to install this product safely,
please call your Ruark Audio dealer or a qualified installer.
Both the R7 and AV Mount are heavy. To avoid injury, we
recommend two people install this product.
Do not apply any load other than the television to the TV
brackets and TV post.
The glass shelf is only intended for normal AV equipement
like blulray players, satellite TV boxes and game consoles.
This product is only for use with a Ruark Audio R7.
spacer
spacer
M8x20
screw
M6x25
screw
reducer
Supplied parts
1x shelf post
1x TV post 2x TV brackets
1x shelf bracket
1x shelf
4x M6x25 screw
2x M6x12 screw
2x thumbscrew
2x washer
1x hex key
4x M8x20 screw
4x spacer
4x reducer
1

2 Fit the TV post to your R7
Disconnect all cables from your R7, they are a
trip hazard.
If you allow the AC cord to be pinched between
parts, this may result in a short circuit or an
electric shock.
Carefully move your R7 so you have clear access
to the back of the cabinet. Do not drag your R7
along the oor as this may damage the legs.
We recommend you place a sheet of card or heavy
fabric on top of the R7 to protect it while you t the
TV post.
Use the hex key provided to remove the four M8
screws on the back of your R7 as shown and then
use the same screws to secure the TV post to the
R7. Ensure the screws are then securely tightened.
3Hang the TV onto the TV post
Carefully lift the television and hang it so that both
sets of hooks on each of the TV brackets fully
engage with both the top and bottom lips of the TV
backplate.
You can make minor adjustments to the tilt of the
television by loosening the two tilt screws by two
turns to allow the tilt bracket to move. Tilt the
television to your desired angle and hold it while
you tighten the two tilt screws.
4Fit optional shelf post
Use the hex key to secure the shelf bracket to the
shelf post using 2x M6x12 screws. Ensure the
screws are tightened correctly.
Slide the shelf post into the base of the TV post
and secure it using the two thumbscrews
provided.
5Fit glass shelf
Slide the glass shelf into place, ensuring it’s
pushed all the way back and centred left to right.
Adjust the height of the shelf.
6Connect cables
Connect all the necessary cables to your television
and AV equipment on the shelf, taking care to
route all cables so that they will not be pinched or
damaged when adjusting swivel position of the
television.
Ruark Audio
59 Tailors Court, Southend on Sea, Essex, SS2 5TH, UK
www.ruarkaudio.com 20140901
tilt screws
2x M6x12 screws
2x M6 thumscrews
2x washers
2
3
4
5

R7 AV Mount