Safavieh CENDRA PLT4011A User manual

Assembly Instruction
CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel
before beginning installation.
ITEM#: PLT4011A
Care and Cleaning
To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water,
never a solvent) to wipe the surface of the fixture.
To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit
breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean
cloth(use clean water, never a solvent) to wipe the interior surface of the fixture
Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth to
dust or wipe carefully.
Estimated Assembly Time:20 minutes
Part List and Hardware List
PIECE
DESCRIPTION
PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY
Amounting
bracket 1X G mounting screw 2X
B machine
screw 2X H ground screw 1X
C backplate 1X J bulb 1X
D washer 2X k Frame 1X
E Cap Nut 2X M screw 2X
Fwire
connector 3X
1

Installation
Step 1
Loose the Screws(M) to remove the polyfoam from the Frame(K)
Step 2
Install the mounting bracket(A) to the junction box with machine screw (B)
Step 3 Wire connection
Make wire connections, with wire connectors(F), following the reference chart listed below.
Connect,Hot,Black or Red outlet Supply Wire to: Connect,Neutral,White Outlet Supply Wire to:
Black White
*Parallel Cord(round&smooth) *Parallel Cord(square&ridged)
Clear,Brown,Gold or Black without Tracer(colored stripes) Clear,Brwn,Gold or Black without Tracer(colored stripes)
Insulated Wire(not green)with copper metal conductor Insulated Wire(not green)with Silver metal conductor
*Note: When parallel wire(SPTI&SPTII)is used. The neutral wire is square shaped and
ridged and the hot wire will be round in shape and smooth.(See illustration on left)
Grounding Instructions:
a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on
mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire,
connect to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding
screw on mounting bracket. Tighten ground screw.
Step 4
Attach the backplate(C) to the junction box and fix it by turning the
washer(D) and screw (E) clockwise
Step 5
Insert the bulbs (J) into the socket (I).
Step 6
connect Frame(K) to the Top Hood(L)by using 2pcs screwS(M) .
PLEASE USE TYPE"C" BULB MAX 40-WATT OR CFL
BULB MAX 13-WATT OR LED BULB MAX 9-WATT
THERE IS 1PC ST58 4 WATT LED BULB IN THE BOX
ENJOY YOUR LAMP
2