Safety Systems LTCMIP183 User manual

Covert Network Camera
Quick Installation Guide
1
2
6
8
7
ALARM
RS232
RXDTXD GND IN1 1B1A
LAN(PoE)
DC12V
RESET
SD
VIN1
AUDIO
OUT
AUDIO
IN
910 11
12 13 14
15
16 17
18
1
2
3
4
5
ALARM
RS232
RXDTXD GND IN1 1B 1 A
LAN(PoE)
DC12V
RESET
SD
VIN1
AUDIO
OUT
AUDIO
IN
910 11
12 13 14
15
16 17
18
Covert Camera with Cylindrical Sensor
Covert Camera with Fixed Focal Unit
Covert Camera with Block-shaped Sensor
Installation of Main Unit
1. Fix the standard mounting rail on the mounting surface.
2. Hang the hook which is on upper-side of the main unit onto the
rail, press a little harder on the lower part of the main unit, and
then the elastic clasp will be automatically buckled.As shown in
below left figure.
If you already had a standard rail to be installed, you can buckle
the main unit onto the installed rail directly.As shown in below
right figure.
Installation of Block-Shaped Sensor Unit
1. Drill on the mounting surface.As shown in below left
figure.
2. Remove a side of the adhesive tape on the bracket. Paste the
bracket on the mounting surface with aligning with the drilling
hole.As shown in below right figure.
3. Install the Block-shaped sensor unit into the bracket and make it
to be buckled.
4. Tighten the fastening screw on the top of the bracket.
No. Descripon No. Descripon
1 Main Unit 11 PoE & Network
2 Power Indicator LED 12 Mounng Rail
3 Status Indicator LED 13 Block-Shaped Sensor Unit
4 Link Indicator Led 14 Decorave Cover
5 Audio Interface 15 Straight Mounng Bracket
6 RJ-12 Cable 16 Cylindrical Sensor Unit
7 Micro SD Card Slot 17 RJ-12 Interface
8 RESET Buon 18 Round Rail Mounng Bracket
9 RS-232 &Alarm Interface 19 Fixed Focal Camera
10 Power Interface 20 Ceiling Mounng Bracket
Note:
Press RESET button about 10s when the camera is powering on or
rebooting to restore the default settings, including the user name,
password, IP address, port No., etc.

Covert Network Camera
3. Screw the bracket to the mounting base.
4. Loop the fixed focal unit with the loop of the bracket, and
tighten it with the supplied screw.
6. Loosen the knob to adjust the surveillance angle, and then
tighten the lock nut to complete the installation.
For detailed instructions of further configuration, please refer to the user
manual of network camera.
Installation of Cylindrical Sensor Unit
1. Drill on the mounting surface.
2. Remove a side of the adhesive tape on the bracket. Paste
the bracket on the mounting surface with aligning with the
drilling hole.
3. Install the cylindrical sensor into the mounting hole in the
round rail bracket.
4. Turn the locking sleeve to fix the sensor.
Installation of Fixed Focal Unit
1. Fix the mounting base of the bracket to the ceiling with the
supplied screws.
2. Hood the bracket cover to the mounting base.
5. Align the assembled fixed focal unit to the bracket, and rotate
the unit to tighten the unit with the bracket.