Prior to use, read this manual carefully and follow all safety precautions to prevent personal injury.
Retain this manual for further reference.
WARNING
Danger of Suocation! Keep children and animals away from the packaging material.
CAUTION
• The solar lights are NOT a toy. Do not leave children and animals unsupervised with the lights.
• Danger of Burns from Battery Acid. If a battery leaks, avoid physical contact with the battery acid.
Wear protective gloves if necessary. If you touch battery acid, rinse the aected area with abundant
fresh water immediately and contact a doctor as soon as possible.
• The solar lights are designed to decorate outdoor areas. The storage batteries charge during the
daytime via the solar cell elds. The accumulated energy allows the LEDs to illuminate at night.
•
The lights are designed for personal domestic use only and are not intended for commercial applications.
•
The lights should only be used as described in these instructions. Any other use is deemed to be improper.
• Protect the lights from open ames and impact.
• Never immerse the lights in water or other liquids. They are only resistant to splashing.
• During extreme weather conditions (e.g. storm, hail) or if the lights will not be used for a long time,
switch them o and store in a dry place.
• Do not disassemble the lights (except for removing the storage battery prior to disposal of the solar
unit)! Have any repairs done only by a specialist workshop or the customer service department. The
LEDs cannot be replaced.
• Storage batteries may not be disassembled, disposed of in re, immersed in liquids or short circuited.
• Keep the solar elds clean so that the greatest possible absorption of light is ensured. Wipe down
the solar elds (and if necessary, also the remaining components of the article) with a damp cloth. Do
NOT use any corrosive or abrasive cleaning agents to clean as they could damage the surfaces.
PRODUCT SPECIFICATIONS
Lumens: 10
Material for Disk: Stainless Steel
Material for Spikes: Plastic
Lifespan: 50,000-100,000 Hours
Water Resistant: IP65
Rust Proof
PRODUCT OVERVIEW
TURNING ON / OFF
1. Slide the On / O switch to the ON position to activate the solar units. The batteries can now charge
in daylight. When dark, the LEDs automatically switch on. When product gets direct sunlight, the
LEDs switch o and the batteries are charged up via the solar elds.
2. When the solar lights are not being used switch them o by sliding the On / O switches to the OFF
position.
PLEASE NOTE: Battery power can be severely impacted by extremely low temperatures.
SET-UP
• The solar lamps should not be placed near to other light sources such as streetlamps or other lamps,
so that the LEDs can be switched on automatically. If the product is placed where it gets direct light
the LEDs will automatically switch o.
• Position the solar lights so that the solar elds are able to absorb direct sunlight prefereably
throughout the whole day.
Mount the ground spikes as follows:
1. Insert the ground spikes into each other:
Slide one piece with a long slot (A) and a piece with a short slot (B)
into each other.
2. Mount the ground spike on the underside of the solar unit.
3. Push the ground spikes into the ground.
Charging time: approx. 6 to 8 hours (in sunlight)
Lighting time: up to 8 hours (with a fully charged storage battery)
