2 - Prior to Connecting to a Network
3 - StartUp Wizard 4 - System Management
1. Connect a keyboard, monitor, and
mouse.
2. Connect the power supply to the
RED3 IS.
3. Log in to Windows (case sensitive)
Username: Administrator
Password: Completeview!
4. Configure the Salient network,
computer name, and other relative
parameters for network
connectively.
After successfully logging into Windows, the CompleteView™ StartUp Wizard will automatically
launch. The Wizard will step though the initial configuration of CompleteView™ server. Contact
Salient support at http://www.salientsys.com/support/contact-support/, or 1-844-SALIENT
(1-844-725-4368) for assistance, if required. The system does come fully licensed with 16 or 24
channels depending on the unit.
The default IP address for the RED3
switch is 192.168.1.50, but can be set
through the web interface.
To configure the RED3 integrated switch,
browse to http://192.168.1.50.
Username: Admin
Password: Completeview!
(case sensitive)
Cameras will connect to ports 1 to 16 or
1 to 24 depending on the unit.
U1 can be used as an uplink to other
network devices and should be reserved
to segment the camera network. U2
should be connected to the client
network, the network address is set
through the Windows Control Panel.
RED3Integrated Server - Quick Start Guide
1 - Packing Contents
RED3 IS
Power Cord
Keyboard and Mouse
Rack EarsSoftware Manual
