Samsara SC21 User manual

For more details on mounting or additional technical information, visit the
Connected Sites knowledge base at samsara.com/support
1x
1x
1x 1x4x 4x 2x
1x
INSTALL GUIDE — FMS
GUIDE D’INSTALLATION — FMS
INSTALLATIONSANLEITUNG — FMS
GUÍA DE INSTALACIÓN — FMS
GUIDA ALL’INSTALLAZIONE — FMS
INSTALLATIEGIDS — FMS
Bullet IP Site Camera
SC21

samsara.com/support 2
4
1 2
3
Attach cable gland if using outdoors
or in a wet environment.
Note: The SC21 has cabling to support different
deployments and features. Only the ethernet
cable is necessary for this install.
If necessary, install drywall anchors
using the alignment sticker for
reference. Feed the ethernet cable
through the middle opening of the
back plate, then fasten the back
plate to the mounting surface using
the provided screws.
If using the SC21 in an outdoor
deployment, attach the sunshield
using the provided screws and Torx
Driver provided.
Loosen the fastening ring.

samsara.com/support 3
Add Cameras
56
78a
Loosen camera pan screw with Torx
driver provided.
When your camera is plugged into
the network, add the camera to your
dashboard by going to Devices >
Cameras > Add Cameras. You can
identify your camera in the results via
the serial and/or MAC address
printed on the camera's box.
Once added, confirm the camera is
positioned correctly by viewing it in
the mobile app or dashboard. The
next steps demonstrate the
different axes you can use to
adjust the camera's field of view.
Optional: Twist camera to rotate.

samsara.com/support 4
9
8b 8c
Optional: Tilt camera. Optional: Tighten the fastening ring.
Tighten camera pan screw with
Torx driver.