Sanus Systems EFB User manual

Assembly Instructions for Model: EFB
Assemble your Sanus Systems Model EFSat, or HTB Speaker Foundation,
attaching the L-Bracket. You will need the EFB Universal Mounting Bracket (sold
separately) to mount the speakers.
Use a Phillips screwdriver to remove the two plastic wall spacers that are on the
back of your speaker, located just above the speaker terminal
plate.
Pull the speaker wires through the wire management and
connect them to your speaker; then, lay the speaker down with
the back facing up.
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2.03.06 (100007)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Speaker
Wires
Open the EFB Package and remove the small Black Spacers and place them over
the holes in the back of your speaker where the two plastic wall spacers were
removed.
Align the top two slots of the EFB over the two small Black Spacers.
Using a Phillips screwdriver, and the two Screws provided with the EFB, secure the
EFB and Spacers to the speaker, taking care as to not overtighten the screws.
EFB
Screws
Spacers
Slide the Speaker and EFB onto the L-Bracket on the stand.
EFB
L-Bracket
Speaker