Sanyo CDP-4000 User manual

siq///4lw
INSTRUCTION MANUAL
Portable Compact Disc Player
CDP-4000
CDP-4000CR

SAFETY CERTIFICATION
CAUTION
USE OF CONTROLS OR ADJUSTMENT OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR
REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSON-
NEL.
A.
E+l
CAUTION -INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS
DEFEATED. AVOIO EXPOSURE TO BEAM,
ADVARSEL -USYNLIG LASER STRALING VED ABNING, NAR
SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION, UNDG+! uDS /ETTELSE
VARNING -OSYNLIG LASER STRALNING NAR DENNA DEL AR OPPNAD
OCH SPARR AR URKOPPLAD. STRALEN AR FARLIG.
~
VORSICHT -UNSICHTBARE LASERSTRAHLUNG TRIIT AUS, WENN DECKEL
GE6FFNET UND WENN SICHERHEITSVERRIEGELUNG i) BERSROCKT IST.
VARO -AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA
NAKyMAm3MALLE tiSER5ATEILYLLE. ALA KATSO SATEESEEN,
1

IPRECAUTIONS
High volume levels can create po- -Do not use where there are extremes
tentially dangerous situations by of temperature (below 5°C or ex-
drowning out surrounding sounds. ceeding 350C).
Use caution when driving while op- Sudden changes inthe ambient tem-
erating the unit, and obey all appli- perature may cause condensation
cable laws. to form on the optical lens inside the
Do not dav your headset at ahiah unit. If this haDDf)fIS. take out the
volume” le;e~. Hearing experts a~-
vise against continuous extended
play.
If you experience aringing in your
ears, reduce the volume or discon-
tinue use.
Do not use while bicycling, running
or operating amotorized vehicle.
The rating label is located on the
bottom of the unit.
The apparatus shall not be exposed
to dripping or splashing.
. . .
disc, leave the unit for about 1hour,
and then proceed to operate.
Do not insert pins, etc., inside the
unit.
This unit is equipped with asafety
device which automatically turns the
laser beam off when the disc com-
partment is opened. If apin or other
metal object should get inside the
unit, however, this safety device may
be deactivated.
2

CONTROLS
.-.+..
1. Disc compartment
2. Anti rolling shock button
(ANTI ROLLING SHOCK)
3. Stop button (STOP)
4. Play mode button (P-MODE)
5. Programme button (PROG)
6. Display
7. Skip/Search buttons
(SKIP/SEARCH)
8. Battery compartment (bottom)
4
9. External DC socket (DC 6V)
10. Line output socket (LINE OUT)
11. Headphones socket (PHONES)
12. Volume control (VOLUME)
13. Bass expander switch
(BASSXPANDER)
14. Continuous play switch
(CONTINUOUS PLAY)
15. Play/Pause button (PLAY/PAUSE)
16. Open switch (OPEN)
17. Hold switch (HOLD) (left side)
567
3
2
1
17
16
3
15 14 i3 i2

IThe buttons on the remote control function in the same way as the corresponding
buttons on the unit.
1. Play/Pause button (WII )
2. Skip/Search buttons
(1+4, FW)
3. Stop button (■)
4. Volume Control (VOL)
234
4

POWER SUPPLY
AC adaptor
Plug one end of the AC adaptor into the
DC 6V socket, then plug the other end
into an AC outlet.
-Use only the supplied AC adaptor
If the AC adaptor is connected. The
power supply automatically switches
to the AC power source and the
installed batteries are disconnected.
Rechargeable battery
1. Install the rechargeable nickel-cad-
mium battety (SANYO NBP-30B) as
shown below. Observe proper polar-
itv.
2. Connect the AC adaptor. The bat-
tery is fully charged approximately
10 hours after the AC adaptor is
connected.
Do not charge continuously for 24
hours or more.
CONTAIN NICKEL-CADMIUM
BATTERY. MUST BE RECYCLED OR
DISPOSED OR DISPOSED OF
PROPERLY.
Alkaline batteries
Install two “AA” batteries (not supplied)
as shown below. Observe proper polar-
ity.
Battey recharging or replacement
If the rechargeable battery or alkaline
batteries are weak and discharged,
“~” blinks on the display, then the
power automatically turns off. If this oc-
curs, recharge the rechargeable battety
or replace the alkaline batteries.
Dispose of all used batteries safety
and in accordance with all appli-
cable laws.
Note:
When you are not going to use the unit
for one month or more, take the batteries
out of the battery compartment.
5

ER ADAPTOR (For CDP-4000CR)
..
The sumiied cigarette lighter adaptor is
designed for us= with ve~icles that have
a12V, negative ground electrical system
Most vehicles have this type of electri-
cal system, but if you are unsure about
the type your vehicle has, contact the
vehicle dealer.
Plug one end of the cigarette lighter
adaptor into the DC 6V socket, then
plug the other end into the cigarette
lighter socket.
Caution:
-Use this unit only with the supplied
cigarette lighter adaptor.
-Be sure to clean the cigarette lighter
socket before use.
-After use, disconnect the cigarette
lighter adaptor.
@
“o“” @
:t
-!!!
n
6

BEFORE OPERATION
Anti rolling shock function
Inthe previous anti-shock function, when
skips occurred while available memory m
runs out, then the sound would suffer ,mAc.M(Ns,.
some interruption.
The new anti rolling shock function is
designed to prevent skipping to the great- -TR.cll me+ m.
est extent possible instead of supple-
menting the S~DDed Dortion of the sound. Note:
This i; achie;ed by expanding the
memory capacity, and in addition full
attention has been given also to increas-
ing the unit’s signal reading capability.
Moreover, consideration has been given
to eliminating the basic causes of
skipping, both from the standpoint of
horizontal shock and vertical shock.
Use this function when listening during
walk or playing in acar.
When the PIAY/PAUSE button ispressed
first time, the anti rolling shock function
turns on automatically. “Y appears on
the display. The “Y changes to “~ when
the buffer memory is full of next 40 sec-
onds music data.
Press the ANTI ROLLING SHOCK
button to turn the anti rolling shock
function off. “~ disappears.
Press the button again to turn it on.
Sound may skip or mute for afew
seconds when you press the ANTI
ROLLING SHOCK button during
play.
Playing may stop when the unit
gets strong shock even when the
anti rolling shock function is on.
7

Bass expander system
Set the BASSXPANDER switch to ON to
~
If the operating buttons do not
enhance the bass sound.
Auto power on function
The power turns on automatically when
PIAY/PAUSE button is pressed
Auto power off function
The power turns off automatically after
about 1minute when all tracks on adisc
have been played or when the STOP
button is pressed once to stop play.
Hold function
The HOLD switch disables the buttons
from operating to prevent play from start-
ing or stopping due to accidental opera-
tion. For normal use, leave the switch in
the off position.
To prevent battery drain:
Set the HOLD switch to the on position
when carrying the unit in abag. The
PLAY/PAUSE button will not function
even ifthe button is pressed accidentally.
“00 0000 HOLD” appears briefly on the
display.
@&&#l
[
2.
3.
Check whether the HOLD switch is
on or not.
Remove the batteries and/or dis-
connect the AC adaptor from the
unit. Wait afew seconds, then rein-
stall the batteries or reconnect the
AC adaptor.
If the buttons still do not function,
insert new batteries or charge the
rechargeable battery.
To prevent play from being interrupted:
Set the HOLD switch to the on position
after starting play. “HOLD” appears.

:,<.-, HANDLING COMPACT DISCS
Use compact discs bearing the symbol -
shown below. In addition to conven-
tional 12 cm CDs without an adaptor.
~rHi
DIGITAL AUDIO
Do not expose the disc to direct -
sunlight, high humidity or high tem-
peratures for extended periods of
time.
-Discs should be returned to their _,
Handle the disc by its edge. Do not
touch the playing surface (glossy
side).
Fingerprints and dust should be care-
fully wiped off the playing surface of
the disc with asoft cloth.
Wipe in astraight motion from the
centre to the outside of the disc.
Never use chemicals such as record
cleaning sprays, antistatic sprays or
fluids, benzene or thinner to clean
compact discs
cases after use. Ine unit will not play adisc that has been
-Do not apply paper or write anything inserted upside down, or discs which do
on the disc surface. not conform to the Compact Disc
standard.
9