SATERNUS 40022-W User manual

ASSEMBLY INSTRUCTIONS FOR A SINGLE TABLE FOR CHESS OR LUDO.
1. Start the assembly with planning the table position, then make a trench with dimensions
of 800mm x 800mm x 230mm (length x width, depth) .
2. Then we level the excavation and insert a concrete pedestal. Screw the cross to the
pedestal and check the level .

3. Backfill the trench, compacting with wooden pegs. It is very important to whip with the
layouts after adding about 10cm.
4. Next, from the center of the pedestal wall, measure the distance of 700mm to the center
of the pin. We dig the size of the prefabricated element for the seat and place the blocks
as shown in the photo so that the top of the prefabricated element is flush with the
ground. They should be properly leveled. .
Important: when covering the prefabricated element under the stool, we translate the
soil layers with mortar or cement to further strengthen the substrate.
5. The next step is to screw the mounting flat bar inside the stool, and put the stool on the
prefabricated .

6. Then we cover it all up and put on the top. If necessary, we put washers under the cross
to get the level of the table top
.