Savage MULTIFLEX LIGHT STAND Manual

®
CONFIGURATIONS AND USES ON REVERSE
PATENT PENDING
MULTIFLEX LIGHT STAND SETUP & USAGE
Stand upright & release strap Slide legs upwards Lock legs at desired heightCarefully fold legs down
SETUP
GETTING STARTED
Your MultiFlex Light Stand features an
innovative, patent pending leg design
that provides extreme functionality
whether in a studio or location
environment. Individually adjustable leg
sections allow for multiple congurations
in a variety of settings.
The bubble level ensures your MultiFlex
Light Stand remains level and secure in
almost any location.
Securing and transporting your MultiFlex
Light Stand is simple with the included
Velcro strap.

CONFIGURATION
USAGE
ADJUSTING THE LEGS ON YOUR STAND IS SIMPLE!
CHECK BUBBLE LEVEL &
ADJUST IF NECESSARY!
CORNERS
To use in a corner, adjust the single leg section so it
is nearly vertical and against the stand body. This leg
will be in the corner. Adjust the double leg sections to
medium height, and extend lower leg
sections to ensure levelness.
Check bubble level.
Alternatively, the base can be lowered all the way to
the oor with the single leg folded away for added
support.
EXTRA STABILITY
When extra stability, or a larger footprint is needed,
adjust all leg sections to a low height for a lower center
of gravity, and wider footprint.
Always check bubble level before attaching light.
*Sandbag weights are recommended as a
precautionary measure when setting up in
unlevel environments or when added
stability is needed.
ADDITIONAL SUPPORT
When extra stability is needed,
or with heavier loads, use the
stand base as added support.
Adjust all leg sections to low height,
and extend lower leg sections until level.
Secure knobs when base is resting
on the ground.
This method can also be used when in corner applications.
STAIRS & STEPS
Adjust the single leg to a
medium-low height and extend
leg section to secure on step.
The double leg sections should
be at a medium-high height.
Extend lower leg sections to
ensure levelness.
Check bubble level.
FURNITURE & OBSTACLES
Set all legs to low height, and adjust
each leg section to clear obstacle.
To ensure the stand is upright and
secure, unlock the single leg
central lock to extend/move
leg to clear any obstacles.
Relock leg lock when stand is
level and in desired position.
UNEVEN TERRAIN
Set both single, and double leg section
locking knobs to a medium height.
Extend lower leg sections accordingly to
provide maximum stability.
Check bubble level.
1) Loosen tob knob to adjust leg height.
2) Grasp stand rmly and move leg up or down.
3) Flip open leg lock located midway down
each leg to extend a second section to
desired length, then ip down lock to secure.
4) Your stand is now ready for use!
UNLOCK