Savage PORT-A-STAND User manual

PORT-A-STAND
USER MANUAL
ITEM: 62037 / 62037-50K
®
SavageUniversal.com
Videndum Media Solutions
2050 S. Stearman Drive, Chandler, AZ 85286 USA

1
2
3
4
5
6 8
9
10
11
7
SETUP
1
2
3
4
5
6
7
8
9
10
11
SETUP
Loosen handle located at top of legs on upright stand (A).
While grasping upright (A) center column, and stand leg, extend stand legs outwards.
Continue extending legs until horizontal supports are parallel to the ground. Tighten handle.
Repeat steps 2-3 with second upright (B).
Extend crossbar (C) by grasping on either side of telescopic sections and twist in opposite
directions until desired width is achieved. Lock in place by twisting in other direction.
Position uprights (A,B) desired width apart (slightly wider than backdrop width).
Completely loosen small handles off both ends of crossbar, in order to place crossbar (C) end collar
over upright (A) top stud. Tighten handle to secure.
Slide backdrop core onto crossbar (C) until crossbar extends through opposite side.
Place remaining crossbar (C) end collar over upright (B) top stud. Tighten handle to secure.
Starting with upper most collar, extend uprights (A,B) to desired height.
Repeat step 8 on opposite upright, ensuring crossbar (C) is level and secure. It may be necessary to raise
uprights in smaller increments on each side, back and forth to extend it smoothly.
Carefully sweep/drape out your backdrop until it reaches the desired length.
Your Port-A-Stand is now ready for use.
PRECAUTIONS
• Maximum weight limit is 25 lbs. (11.34kg)
• It is best practice to use a sandbag around the base of the each upright for added stability.
(A) (B) (C)