Savoy SleepFans 12SF User manual

OWNER’S MANUAL
12” TABLE TOP
READ AND SAVE THESE INSTRUCTIONS
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 1／8页

PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 2／8页

TOOLS REQUIRED
 -FlatHeadScrewdriver
PACKAGE CONTENTS
 A.FanHead
 B.FanBase
 C.FlatHeadScrew
 D.FrictionKnob
FANACTIVE
NEUTRAL
A.
B.
C.
D.
1
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 3／8页

2
SAFETY AND WARNINGS
● Pleasereadallinstructionsbeforeoperating
thisFan.
● DONOToperateFanuntilfullyassembled.
● UseFanonlyforintendedhouseholduseas
describedinthismanual.Anyotherusenot
recommendedbythemanufacturermaycause
re,electricshock,orinjurytopersons.
● DONOToperateFanwithoutgrillsproperlyin
place.
● Alwaysuseonadry,stable,levelsurface.
● Avoidcontactwithmovingparts.NEVERinsert
ngers,pencilsoranyotherobjectsthroughthe
Fangrillduringoperation.
● Toavoidreorshockhazard,plugthe
appliancedirectlyintoa120VACelectrical
outlet.Connectonlytoproperlypolarized
outlets.
● Alwaysinsertorremoveplugfromtheoutletby
grabbingtheplugbyhand.DONOTpullonthe
electricalcord.
● Keepthecordoutofheavytrafcareastoavoid
accidentaltrippingorcontact.DONOTletthe
cordhangovertheedgeofatableorcounter.
Toavoidrehazard,NEVERputthecordunder
rugs,nearheatregisters,radiators,stovesor
heaters.
● AlwaysunplugFanbeforemovingit,puttingon
ortakingoffparts,cleaning,orwheneverthe
Fanisnotinuse.
● DONOToperateFanwithadamagedcord
orplug,ifFanmotorfailstorotate,afterthe
Fanmalfunctions,orifithasbeendroppedor
damagedinanymanner.TakeFantoqualied
technicianforassessmentand/orrepair.
● Toreducetheriskofreorelectricshock,DO
NOTuseFanwithanysolid-statespeedcontrol
device.
● DONOTattempttorepairoradjustany
electricalormechanicalfunctionsonthis
appliance.Doingsowillvoidthewarranty.
Theinsideoftheappliancecontainsnouser
serviceableparts.Allservicingshouldbe
performedbyqualiedtechnician.
● DONOToperateFandirectlyadjacentto
curtains,plants,windowcoverings,etc.toavoid
accidentalentanglement.
● DONOTuseoutdoors.
● DONOTexposeFantoexcessiveheator
humidity,asthiscancausedamagetothe
electricalcomponents.
● DONOToperateinthepresenceofexplosive
and/orammablefumes.
● KeepFanawayfromheatedsurfacesandopen
ames.
● Toprotectagainstelectricalhazards,DONOT
immerseinwaterorotherliquids.DONOTuse
nearwater.
● KeepFanoutofthereachofchildrenandpets.
● DONOTexposeinfantsorseniorstoprolonged
periodsofdirectcoldair.
● Closesupervisionisnecessarywhenany
applianceisusedbyornearchildren.
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 4／8页

ASSEMBLY INSTRUCTIONS
● WhilesupportingtheFanHead,aligntheQuick
ConnectelectricalblockextendedfromtheFan
HeadNeckwiththeexposedelectricalwires
fromtheFanBase.
● InsertoneoftheelectricalwiresfromtheFan
BaseintotheQuickConnectsidelabeled“N”
andtheotherwireintotheQuickConnectside
labeled“L”.
● UsingaFlatHeadScrewdriver,tightentheQuick
Connectscrewstosecurethewireconnections.
FANACTIVE
NEUTRAL
FANACTIVE
NEUTRAL
NL
● SlidetheQuickConnect,wiringandFanHead
NeckintotheFanBase,andalignthefront
screwholeontheFanBasewiththeslotinthe
FanHeadNeck.
● UsingaFlatHeadScrewdriver,insertand
tightentheFlatHeadScrewtosecuretheFan
HeadtotheFanBase.TheSlotallowstheFan
Headtobeadjustedtotheleftorright.
● InserttheFrictionKnobandhandtightentox
thepositionoftheFanHead.
FanHead
Neck
QuickConnect
FanBase
FrictionKnob
FlatHead
Screw
Slot
3
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 5／8页

4
●  Onceassembled,setthefanonadry,stable,
levelsurface.
●  AdjusttheSpeedControlKnob(A)forthe
desiredairowsetting.
  0: Off
  I: HighSpeed
  II: MediumSpeed
  III: LowSpeed
●  MovetheVolumeActuatorLever(B)upor
downforthepreferredamountofsound.
●  TheFancanoperateinoscillatoryorstationary
mode.PresstheOscillationKnob(C)down
toactivatetheoscillatingmode.Tostop
oscillation,pullknobup.
●  TurnfanoffbeforeadjustingFanHeadtilt
angle.
●  ToadjusttheFanHeadangle,grasptheFan
HeadandslightlyloosentheTiltAdjustment
Knob(D).TilttheFanHeadupordownand
holdinthedesiredpositionwhilere-tightening
theTiltAdjustmentKnob(D).
●  ToadjusttheFanHeadleftorright,loosen
theFrictionKnob(E).TurntheFanHeadto
thedesiredpositionandre-tightentheFriction
Knob(E).
●  Unplugthefanwhennotinuse.
CLEANING & MAINTENANCE
CLEANINGTHEFAN
●  Setthespeedcontrolknobtooffandunplug
theappliance.
●  Cleanthefanheadandbaseusingaclean,soft
cloth,slightlydampened,ifnecessary.Make
certainthatallsurfacesarecompletelydry
beforeresuminguse.
●  NEVERuseabrasivecleaningagents
orsolvents.Thismaycausedamageor
deteriorationtothesurfaceoftheappliance.
●  DONOTimmersethefaninanyformofliquid.
DONOTallowwatertodriponorintothefan
motorhousing.
CLEANINGTHEBLADESANDPETALS
●  Makecertainfanisunplugged.Removethe
safetyscrewandnutlocatedatthebottomof
thegrills.Unlockthemetalclipsonthefangrill
andremovethefrontgrillbyliftingslightlyto
detachthetopalignmenttabfromthebackgrill.
●  Thefanblade,petals,andgrillmaybe
cleanedwithasoftcloth,slightlydampened,if
necessary.Asmall,soft,cleanbrush,(asmall
paintbrushwilldo),mayalsobeusedtoremove
dustinhard-to-reachplaces.
●  NEVERuseabrasivecleaningagentsor
solventsontheblades,petalsorgrill.Thismay
causedamageordeteriorationtothesurfaces.
●  Reattachthefrontgrilltothefanafterallparts
havedriedcompletely.Todoso,securethetop
alignmenttabtothebackgrill.Alignthefront
grillagainstthereargrillandsnapthegrillclips
closed.Reattachthesafetyscrewandnut.
  DONOTplugthefanintoanelectricaloutlet
untilitisfullyreassembled.
OPERATING INSTRUCTIONS
A.
B.
C.
D.
E.
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 6／8页

REPLACING THE OVERLOAD
PROTECTION FUSE
Thisfanemploysanoverloadprotection(fuse).A
blownfuseindicatesanoverloadorshort-circuit
situation.Ifthefuseblows,unplugthefanfrom
theelectricaloutlet.Replacethefuseperthe
instructionsbelowandchecktheproduct.Ifthe
replacementfuseblows,ashort-circuitmaybe
presentandtheproductshouldbediscarded
ortakentoanauthorizedservicefacilityfor
examinationand/orrepair.
●  Unplugthefanfromtheelectricaloutlet.Place
theplugonarm,atsurface.Openthefuse
cover,locatedonthetopoftheplug,usingyour
thumboraatheadscrewdrivertoslidethe
covertowardstheprongs.

NOTE:Ensurethatthefusecoveriscompletely
openbeforeattemptingtoremovethefuse.
●  Removethefusecarefullybyusinga
smallscrewdrivertoprythefuseoutofthe
compartmentbythemetalendsofthefuse.
●  Insertanew5Amp,125Voltfuse(provided
withproduct)intothefusecompartment,making
surethatthefuseissecurelyinplace.
●  Slidethefusecoverclosedcompletely.Ifthe
fusecoverisdifculttoclose,makesurethe
fuseisproperlysecuredinplacebypressing
downonthemetalendsofthefuse.

CAUTION:Riskofre.DONOTreplacethe
attachmentplug.Itcontainsasafetydevice(fuse)
thatshouldnotberemoved.DONOTusethe
productiftheattachmentplugisdamaged.
Toavoidariskofre,onlyreplacewitha5Amp,
125Voltfuse.Foryourconvenience,checkatyour
localhardwarestoreforareplacementfuse.
5
Plug with open
fuse cover
exposing fuse
compartment.
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 7／8页

ExclusivelyDistributedby
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS
PLA13032601
PLA13032601 新版 SIZE:216x280mm 80g模糙纸 8P 单黑色 骑马钉 2013-07-19 第 8／8页