Saxby Lighting 81850 User manual

Thank you for purchasing this accessory. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Please retain these instructions for future reference.
92823
92822
81850
Check you have all necessary prts:
www.saxbylighting.com
Instruction manual
81850, 92822, 92823
Stratus Surface Mount Kit
81850: - 8 x plastic plugs
- 8 x screws
- 2 x mounting frame pieces with fixing holes
- 2 x mounting frame pieces without fixing holes
- 4 x corner connectors
92822: - 8 x plastic plugs
- 8 x screws
- 2 x mounting frame pieces with fixing holes
- 2 x mounting frame pieces without fixing holes
- 4 x corner connectors
92823: - 8 x plastic plugs
- 8 x screws
- 2 x mounting frame pieces with fixing holes
- 2 x mounting frame pieces without fixing holes
- 4 x corner connectors

These surface mount kit are designed only for use with Stratus Panels.
81850 surface mount kit is suitable for 595*595 Stratus panels.
92822 surface mount kit is suitable for 1195*595 Stratus panels.
92823 surface mount kit is Suitable for 1195*295 Stratus panels.
Please refer to the installation instructions supplied with the fitting for wiring and connection details.
Note that the switch is turned off before installation.
The ceiling surface must be flat and smooth to ensure a good fit.
2. Slide two mounting frames B(with fixing holes) separately into a mounting
frame A(with conner connectors) and push to secure (See Fig.1). Ensure the
2 opposite sides of the 3 sided frame have fixing holes. (See Fig.2)
3. Using the part-assembled frame as a template, mark and drill the fixing holes
on the ceiling. Take care not to damage any concealed wiring or pipes.
Then fix the part-assembled frame to ceiling using the supplied plastic plugs
and screws.
(See Fig.3)
5. Slide the fourth frame A(with two conner connectors ) into the
part-assembled and push to secure (See Fig.5).
6. Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Recycling advice
Safety information
For your safety, always switch off the power supply before cleaning.
Fig.4
4. Referring to Fig.4, connect the driver as per the instruction manual supplied
with the Stratus Panels and carefully slide the panel into the 3 sided frame.
Fig.2
Fig.5
Fixing holes must be
opposite each other
Fig.1
92822: 600mm W x 1200mm L
81850: 600mm W x 600mm L
92823: 300mm W x 1200mm L
Installation
Fig.3
Ceiling
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check
with your Local Authority or local store for recycling advice.
1. Using four conner connectors connect to two mounting frames (without fixing holes)
and push to secure. After completion such as mounting frame A( See Fig. 1).
4 x2 x2 x
+ =
A
B
Conformity with all relevant UKCA Directive requirements.
V8 24/10/2022
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
UK Manufacturer: BH17 7BY
* Product images may vary.