HHDC2002 /HHCP2002 Connectivityfor Omnimedia cables QuickStart Guide
070712_HHDC2002_QSG_EN.doc Page 1 Schrack
Required tools:Screwdriver, Cutter, Flush cutter.
Make a small (+/- 3 cm) incision at the end of the cable
and peel open the cable jacket.
Locate the rip-cord and tear the cable open over a
length of +/- 10 cm.
Cut the rip-cord and make a small incision in the outer
jacket (perpendicular to the cable).
Tear-off the outer jacket.
Make a small incision in the outer shielding foil.
Tear-off the outer shield, locate the drainwire and
wind the drain wire around the outer shield.
Make a small incision in the shielding of the brown
pair and tear off the foil.
Remove and cut the foam foils around the other pairs.
Place the backcover over the cable.The restof the
procedure is similar for both typesofconnectors.
Preposition the pairs for easyinsertion in the wire
organizer.
Slide the wire organizer over the pairs and push itin
the backcover.
Verifythat the organizer sits on the bottom of the back
cover. Correctbypulling the wires.
Firmlypull the wiresin the wire organizer, starting with
the brownpair then the blue pair.
The wire organizer must be held down in the back
cover at all times!
HHCP2002….
HHDC2002
Orange
Brown
Blue
Green
HHDC2002 -> 2,5 cm
