SD Card Duplicator
920-0001-01
SCM PC-Card GmbH Page 4 of 6
Sperl-Ring 4 / Hettenshausen
D- 5276 Pfaffenhofen / Ilm Created on 2010-05-21
Tel.:+49 (0) 4 41 / 7 - 10 Hotline: hotline@scm-pc-card.de Subject to change without notice.
Fax: +49 (0) 4 41 / 7 - 900 Internet: http://www.scm-pc-card.de Non contractual document.
Operation Description
Copy operation
Follow the steps below to begin copy operation:
a. Make sure that the capacity of memory card receiving content is adequate (larger than or equal to) the size of
allocated space of memory card containing original copy of content.
b.
Insert memory card with original copy of content to SLOT-0.
c.
Insert memory card receiving content to SLOT-1, 2, to 8.
d. Wait until all slots with memory card illuminated “BLUE” led.
(“BLUE” led indicates memory card properly initialized & identified.)
(“RED” led indicates possibly defective or incompatible memory card.)
e. Scroll up/down menu to “COPY GO!.”
f. Press “ENTER” button to start copy operation.
g. “AMBER” led will be lit indicating active data transfer or “BUSY” status.
h. When copy operation is completed, content will be automatically verified if “VERIFY” option is toggled ON.
i. If content in memory card is verified successfully, “GREEN” led will be lit. Otherwise, “RED” led will be lit.
Verify operation
Follow the steps below to begin verify operation.
a. Insert memory card with original content to SLOT-0.
b. Insert memory card to be verified to SLOT-1, 2, 3 to 8.
c. Wait until all slots with memory card illuminated “BLUE” led.
(“BLUE” led indicates memory card properly initialized & identified.)
(“RED” led indicates possibly defective or incompatible memory card.)
d. Scroll up/down menu to “VRFY GO!.”
e. Press “ENTER” button to start copy operation.
f. “AMBER” led will be lit indicating active data transfer or “BUSY” status.
g. If content in memory card is verified successfully, “GREEN” led will be lit. Otherwise, “RED” led will be lit.
NOTE:
Depends on setting of operation mode, verification will be performed on sector-to-sector based (ON) or file-
to-file based.
Test Mode operation
A test utility is equipped in SD Card Duplicator for basic functionality test and ROM image update.
Follow the steps below to enter Test Mode:
Entering Test Mode
a. Switch off power of SD Card Duplicator.
b. Press ENTER button and then, while pressing down ENTER, switch on power of SD Card Duplicator.
c.
The Test Mode menu of SD Card Duplicator is available and described as below:
d.
Scroll UP/DOWN the menu and select desire item by pressing ENTER.
