Scott Aerator Bubble Pro User manual

1
©2020 U.S. Solar Mounts Corp. All Rights Reserved
1. Position the Upper & Lower Support Arms as shown
in Figure 1 to the right.
2. Slide the Arms together so that the alignment slots
are fully engaged.
3. Set the assembled Arms onto the Base and align the
mounting holes.
4. Insert 8 Carriage Bolts from the bottom of the base
upward through the bent feet.
5. Install a Serrated-Flange Nut onto all 8 Bolts.
6. Tighten all hardware securely.
Bubble Pro High-Efficiency O2 Diffuser
Assembly Instructions REV1
Package Contents
A
1
Aeration Bubble Tube
B
2
Hose Clamp
C
1
Check Valve Assembly
D
10
10-24 x ½” Carriage Bolt
E
10
10-24 Serrated Flange Nut
F
1
Base
G
1
Hose Strain Relief Clamp
H
1
Lower Support Arm
I
1
Upper Support Arm
E
D
F
I
A
B
C
H
G
Figure 1

2
©2020 U.S. Solar Mounts Corp. All Rights Reserved
7. Starting at the location above the handle, feed the
Bubble Tubing through the 4 support rings. The blue
stripe should be on the bottom side and the ends of
the tubing should meet in the center of the starting
space above the handle location.
8. Slide a Hose Clamp onto each end of the Bubble Tube
as shown in Figure 3. Install with the bolt on the
underside of the Bubble Tube and facing outward.
Note: The check valve assembly is shipped with a 3/8” barb fitting
installed. If you need to change it to ½”, remove the 3/8” barb and
install the provided ½” barb fitting.
9. Insert the barbed Tee fitting into the ends of the
Bubble Tubing. You will likely need to grip both ends of
the tubing and “wiggle” it onto the Tee. Make sure
that the Bubble Tubing is fully seated onto both sides
of the Tee and the Tee is pointed slightly downward
and toward the center of the base.
10. Tighten the hose clamps securely.
11. The DB36-B will accept a 3/8” or 1/2” airline. Position
the Strain Relief Clamp so that the appropriate size
notch is facing up.
12. Slide the airline through the Clamp and underneath the
Support Arm Assembly.
13. Install a hose clamp onto the end of the airline
14. Connect the airline to the barb fitting
15. Tighten the hose clamp.
16. Install the 2 remaining Carriage Bolts and Nuts through
the Strain Relief Clamp and tighten securely.
Note: The ¼” hole located at the top-center of the Upper Support
arm is for attaching a marker/float, if installed.
Figure 2
Figure 3
If you have any questions, comments
or need help, Please Contact Us.
U.S. Solar Mounts Corp.
3498 Acorn Ave.
Sparta, WI 54656
[phone]
[e-mail]
Figure 4
Completed Diffuser Assembly