Sea Eagle PaddleSki 435ps User manual

Sea Eagle Boats
435ps PaddleSki Motor Mount and Swivel Seat Fishing Rig
Page 1
Center Motor Mount (MMCPS)
Lay the assembled motor mount board over the yoke bolts, and
secure with the threaded knobs (knurled nuts).
Run strap through front D-ring and under motor
mount board. Buckle must be upside down.
Run strap back over board and to buckle.
Do not run strap through rear D-ring. Using front
D-ring only will keep front edge of board from tilting
up when under power.
Run strap through buckle and pull hard.
Swivel Seat Fishing Rig
Place the assembled frame between the D-rings in front of
the motor mount.

Motor Mount and Swivel Seat Fishing Rig
Page 2
Run strap through front D-ring and under the front bar.
Run strap back over front bar and through the D-ring.
Keep feeding the strap through the D-ring until strap is
tight around the bar.
Next, run strap through D-ring behind rod holder bar as shown.

Motor Mount and Swivel Seat Fishing Rig
Page 3
Run strap back over top of rear bar and front bar and into the
buckle. Pull strap tight.
Free end can be trimmed down or run through back of buckle
and tucked under strap.